The main objective of this paper is to simulate the springback using combined kinematic/isotropic hardening model. Material parameters in the hardening model are identified by an inverse method.Three-point bending test is conducted on 6022-T4 aluminum sheet. Punch stroke, punch load, bending strain and bending angle are measured directly during the tests. Bending moments are then computed from these measured data. Bending moments are also calculated based on a constitutive model. Material parameters are identified by minimizing the normalized error between two bending moments. Micro genetic algorithm is used in the optimization procedure. Stress-strain curves is generated with the material parameters found in this way, which can be used with other plastic models.ABAQUS/Standard 5.8, which has the combined isotropic/kinematic hardening model, is used to simulate draw-bend of 6022-T4 series aluminum sheet. Absolute springback angles are predicted very accurately.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Springback Prediction Using Combined Hardening Model


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Lee, J. K. (Autor:in) / Zhao, K. M. (Autor:in)

    Kongress:

    International Body Engineering Conference & Exposition ; 2000



    Erscheinungsdatum :

    2000-10-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Springback prediction using combined hardening model

    Zhao,K.M. / Lee,J.K. / General Motors,US et al. | Kraftfahrwesen | 2000


    Springback Analysis with a Modified Hardening Model

    Geng, Lumin / Wagoner, R. H. | SAE Technical Papers | 2000


    Springback analysis with a modified hardening model

    Geng,L. / Wagoner,R.H. / Ohio State Univ.,Columbus,US | Kraftfahrwesen | 2000