Piping containing flaws that exceed the Acceptance Standards of Section XI of the ASME Code is evaluated using analytical procedures described in Section XI to determine plant operability for the evaluated time period. Subarticle IWB-3640 of Section XI provides allowable axial and circumferential part-through-wall flaws determined from limit load criteria. ASME Section XI Code Case N-494-3 also provides evaluation procedures based on use of a failure assessment diagram to determine allowable flaw sizes. To understand the allowable flaw sizes determined by the limit load criteria and the failure assessment diagram procedure, austenitic stainless steel pipes with axial part-through-wall flaws with a wide range of pipe diameters were analyzed. The allowable flaw depth based on limit load from Code Case N-494-3 was determined to be very close to that determined from IWB-3640 of Section XI, when the predicted failure mode is elastic-plastic fracture. It was found that the allowable flaw depths derived from the failure assessment diagram procedure of Code Case N-494-3, are lower, but are not significantly different, from those determined from the limit load criteria of IWB-3640. This is due to the relatively high fracture toughness that was used for the austenitic stainless steel.
Allowable axial flaw sizes for stainless steel pipes derived from limit load criteria and failure assessment diagram procedure
2003
6 Seiten, 8 Quellen
Conference paper
English
Allowable sizes of axial flaws in pressurized pipes made of moderate toughness materials
Tema Archive | 1999
|Forming limit diagram prediction (FLD) of stainless steel sheets
Automotive engineering | 2007
|Allowable limit of lateral pressure on railway track
Engineering Index Backfile | 1963
|Allowable limit of lateral pressure on railway track
Engineering Index Backfile | 1965
|Forming Limit Diagram Prediction of Stainless Steels Sheets
SAE Technical Papers | 2007
|