In the study presented in this paper a single-cylinder Scania D12 diesel engine has been converted to work as a pneumatic hybrid. During pneumatic hybrid operation the engine can be used as a 2-stroke compressor for generation of compressed air during vehicle deceleration and during vehicle acceleration the engine can be operated as an air-motor driven by the previously stored pressurized air.The compressed air is stored in a pressure tank connected to one of the inlet ports. One of the engine inlet valves has been modified to work as a tank valve in order to control the pressurized air flow to and from the pressure tank.In order to switch between different modes of engine operation there is a need for a VVT system and the engine used in this study is equipped with pneumatic valve actuators that uses compressed air in order to drive the valves and the motion of the valves are controlled by a combination of electronics and hydraulics.This paper describes the introduction of new tank valve geometry to the system with the intent to increase the pneumatic hybrid regenerative efficiency. The new tank valve has a larger valve head diameter than the previously used setup described in [1], in order to decrease the pressure drop over the tank valve. In order to ensure tank valve operation during high in-cylinder pressures the valve is combined with an in-house developed pneumatic valve spring which makes the tank valve pressure compensated.A comparison between the old and the new tank valve geometry and their effect on the pneumatic hybrid efficiency has been done. Also, optimization of the valve timings for both CM (Compressor Mode) and AM (Air-motor Mode) has been done in order to achieve further improvements on regenerative efficiency.


    Access

    Check access

    Check availability in my library

    Order at Subito €


    Export, share and cite



    Title :

    Investigation of Different Valve Geometries and Vavle Timing Strategies and their Effect on Regenerative Efficiency for a Pneumatic Hybrid with Variable Valve Actuation


    Additional title:

    Sae Int. J. Fuels Lubr
    Sae International Journal of Fuels and Lubricants


    Contributors:

    Conference:

    2008 SAE International Powertrains, Fuels and Lubricants Congress ; 2008


    Published in:

    Publication date :

    2008-06-23


    Size :

    18 pages




    Type of media :

    Conference paper


    Type of material :

    Print


    Language :

    English






    FPGA Controlled Pneumatic Variable Valve Actuation

    Milosavljevic, Alexandar / Johansson, Bengt / Tunestål, Per et al. | SAE | 2006


    FPGA controlled pneumatic variable valve actuation

    Trajkovic,S. / Milosavljevic,A. / Tunestal,P. et al. | Automotive engineering | 2006


    Modern strategies of variable valve actuation

    Demmelbauer-Ebner, W. / Associazione Tecnica dell'Automobile; Sezione Toscana | British Library Conference Proceedings | 1994