For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge—Cross Sections Loader Straight," SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters. This document has been reaffirmed to comply with the SAE 5-Year Review policy.
Cutting Edge—Cross Sections Loader Straight with Bolt Holes
2006-02-05
Conference paper
English
CUTTING EDGE—CROSS SECTIONS LOADER STRAIGHT WITH BOLT HOLES
SAE Technical Papers | 1985
Cutting Edge - Cross Sections Loader Straight with Bolt Holes
SAE Technical Papers | 2011
Cutting Edge—Cross Sections Loader Straight
SAE Technical Papers | 2006
CUTTING EDGE - CROSS SECTIONS LOADER STRAIGHT
SAE Technical Papers | 1985
Cutting Edge - Cross Sections Loader Straight
SAE Technical Papers | 2011