A piezoelectric sensor to measure the mass of fuel that impacts the piston top during injection in a direct injection spark ignition (DISI) engine was developed. The sensor used a 3.18 cm (1.25-inch) long, 0.318 cm (0.125-inch) wide piezo bending motor. The principle of operation is based on the change in natural vibration frequency that occurs to the cantilever piezo beam due to a change in its mass caused by the presence of liquid fuel on its surface. An electrical impulse is used to set the piezo element in vibration after which the natural vibrational frequency is measured using a FFT analyzer. The concept was evaluated outside the engine and calibrated for the frequency shift as a function of the weight of liquid on the bending element. The change in the frequency was found to be approximately proportional to the liquid mass on the sensor. The piston top of the engine was modified to accommodate the sensor on its surface. Due to temperature limitations, all fuel film mass measurements were taken under motored conditions. A wide range of equivalence ratios and injection timings were considered in the experiments. The measurements showed that the fuel film mass deposited on the sensor surface was small, typically less than 2 mg, which corresponds to a film height of 32 μm. The fuel film mass followed a general trend increasing in value and reaching a maximum for injection timings when the piston surface approached TDC. The maximum measured mass for stoichiometric operation was 2.3 mg at TDC and corresponds to 6.3% of the fuel injected. The average evaporation rate of the fuel film mass was 3.3 kg/m2-s, and was nearly the same for all injection timings. The average measurement uncertainty was calculated as ±0.56 mg for stoichiometric operation.


    Access

    Check access

    Check availability in my library

    Order at Subito €


    Export, share and cite



    Title :

    A Piezoelectric Sensor Concept for Measuring Piston Wetting in DISI Engines


    Additional title:

    Sae Technical Papers


    Contributors:

    Conference:

    Powertrain & Fluid Systems Conference & Exhibition ; 2005



    Publication date :

    2005-10-24




    Type of media :

    Conference paper


    Type of material :

    Print


    Language :

    English




    A piezoelectric sensor concept for measuring piston wetting in DISI engines

    Camacho,A. / Hall,M.J. / Univ.of Texas at Austin,US | Automotive engineering | 2005


    The Effects of Fuel Volatility and Structure on HC Emissions from Piston Wetting in DISI Engines

    Ellzey, Janet / Matthews, Ronald D. / Alger, Terry et al. | SAE Technical Papers | 2001


    The effects of fuel volatility and structure on HC emissions from piston wetting in DISI engines

    Huang,Y. / Alger,T. / Matthews,R. et al. | Automotive engineering | 2001


    Stratified Mixture Formation and Piston Surface Wetting in a DISI Engine

    Yi, Jianwen / Trigui, Nizar / Han, Zhiyu | SAE Technical Papers | 2002


    Stratified mixture formation and piston surface wetting in a DISI engine

    Han,Z. / Yi,J. / Trigui,N. et al. | Automotive engineering | 2002