Advantages of flight at high angles of attack include increased maneuverability and lift capabilities. These are beneficial not only for fighter aircraft, but also for future supersonic and hypersonic transport aircraft during take-off and landing. At high angles of attack the aerodynamics of the vehicle are dominated by separation, vortex shedding and possibly vortex breakdown. These phenomena severely compromise the effectiveness of conventional control surfaces. As a result, controlled flight at high angles of attack is not feasible for current aircraft configurations. Alternate means to augment the control of the vehicle at these flight regimes are therefore necessary. The present work investigates the augmentation of an aircraft flight control system by the injection of a thin sheet of air tangentially to the forebody of the vehicle. This method, known as Forebody Tangential Blowing (FTB), has been proposed as an effective means of increasing the controllability of aircraft at high angles of attack. The idea is based on the fact that a small amount of air is sufficient to change the separation lines on the forebody. As a consequence, the strength and position of the vortices are altered causing a change on the aerodynamic loads. Although a very effective actuator, forebody tangential blowing is also highly non-linear which makes its use for aircraft control very difficult. In this work, the feasibility of using FTB to control the roll-yaw motion of a wind tunnel model was demonstrated both through simulations and experimentally. The wind tunnel model used in the experiments consists of a wing-body configuration incorporating a delta wing with 70-degree sweep angle and a cone-cylinder fuselage. The model is equipped with forebody slots through which blowing is applied. There are no movable control surfaces, therefore blowing is the only form of actuation. Experiments were conducted at a nominal angle of attack of 45 degrees. A unique apparatus that constrains the model to two degrees-of-freedom, roll and yaw, was designed and built. The apparatus was used to conduct dynamic experiments which showed that the system was unstable, its natural motion divergent. A model for the unsteady aerodynamic loads was developed based on the basic physics of the flow and results from flow visualization experiments. Parameters of the aerodynamic model were identified from experimental data. The model was validated using data from dynamic experiments. The aerodynamic model completes the equations of motion of the system which were used in the design of control laws using blowing as the only actuator. The unsteady aerodynamic model was implemented as part of the real-time vehicle control system.
Experiments in Aircraft Roll-Yaw Control using Forebody Tangential Blowing
1997
187 pages
Report
No indication
English
Aerodynamics , Aircraft , Roll , Yaw , Forebodies , Flight control , Tangential blowing , Vortices , Aircraft control , Control simulation , Angle of attack , Flow visualization , Wind tunnel models , Wind tunnel tests , Aerodynamic characteristics , Mathematical models , Computerized simulation , Maneuverability , Controllability , Aerodynamic loads , Body-wing configurations , Hypersonic aircraft , Sweep angle , Control surfaces , Degrees of freedom , Vortex shedding , Vortex breakdown , Stability augmentation
Nonlinear Control Using Forebody Tangential Blowing
British Library Conference Proceedings | 1998
|Nonlinear control using forebody tangential blowing
AIAA | 1998
|Nonlinear Control Using Forebody Tangential Blowing
British Library Conference Proceedings | 1998
|Forebody Tangential Slot Blowing on an Aircraft Geometry
NTRS | 1994
|Yaw Control by Tangential Forebody Blowing
British Library Conference Proceedings | 1994
|