In the present study, a numerical simulation was conducted to investigate the influence of surface roughness on the aerodynamic performance of a 1.5-stage highly loaded axial compressor at low Reynolds number. It was especially considered how the roughness Reynolds number (k+) affected the change of the inlet and outlet conditions, the growth of the separation bubble (LSB), the status of the limiting streamline, and the patterns of the wake. Regarding the roughness settings, five roughness magnitudes and four roughness locations were mainly studied. The results showed that at low Re, surface roughness mainly improved the stage performance by reducing the length and width of the LSB as well as the rotor tip vorticity, delaying the occurrence of three-dimensional flow separation and increasing the turbulence level near the wall. However, it also aggravated the incoordination between the subsequent stages to a certain extent, which limited further improvement of the overall aerodynamic performance. Generally, with k+ increasing, the compressor aerodynamic performance improved and achieved the best at k+=137.8. The maximum increases in the total pressure ratio, peak efficiency, and chocked mass flow were approximately 4.01%, 5.34%, and 2.24%, respectively. In addition, for all the four roughness locations, the roughness covering from the leading edge to 50% of the axial chord length on the suction surface had a relatively evident advantage in improving the compressor peak efficiency because of the better control of the LSB and wall shear stress.
Influence of Surface Roughness on a Highly Loaded Axial Compressor Stage Performance at Low Reynolds Number
2021
Article (Journal)
Electronic Resource
Unknown
Metadata by DOAJ is licensed under CC BY-SA 1.0
Aerodynamic design of a highly loaded supersonic aspirated axial flow compressor stage
Online Contents | 2014
|