A helmet drying machine is a device used to dry a helmet in a relatively short time. This helmet dryingmachine is divided into two parts namely: slicer/extortion machine and dryer. This slicer/squeezer machineserves to reduce the water content contained in the helmet up to 60-80%. In planning theoretically discussthe main components of the slicer transmission system on the helmet drying machine that determines: thediameter of pulley, the rotation ratio of the pulley, the shaft axis distance, the shaft diameter of the pulley II,and the bearing number. From the calculation results obtained as follows: 0.25 HP motor crusher power,electric motor rotation 1400 rpm, diameter pulley I 65 mm, diameter pulley II 130 mm, rotation ratio at 1:2pulleys, distance between the axis 251.32 mm axis, the diameter of the shaft on the pulley II 20 mm, and thenumber of open type 6004 bearings.Keywords: transmission system, pulleys and belts, shaft and bearing.
PERENCANAAN SISTEM TRANSMISI ALAT PENIRIS PADA MESIN PENGERING HELM
2018-01-27
doi:10.55679/enthalpy.v3i1.3629
Enthalpy : Jurnal Ilmiah Mahasiswa Teknik Mesin; Vol 3, No 1 (2018): Enthalpy: Jurnal Ilmiah Mahasiswa Teknik Mesin ; 2502-8944 ; 10.55679/enthalpy.v3i1
Article (Journal)
Electronic Resource
English
DDC: | 629 |
PERANCANGAN SISTEM TRANSMISI MESIN PRES BIJI KELOR DENGAN PUTARAN MESIN 1400 RPM
BASE | 2020
|Desain Sistem Mekanik pada Transmisi Motor Matik untuk Keselamatan Pengendara
BASE | 2019
|Karakteristik Alat Uji Sistem Pendorong pada Autonomous Underwater Vehicle (AUV)
BASE | 2012
|