BEARING, PLAIN, SELF-ALIGNING, GROOVED OUTER RING
BEARING, SLEEVE, PLAIN, SELF-LUBRICATING, -65 °F TO 325 °F
Reconstruction of Wheel Forces Using an Intelligent Bearing
BEARING, SLEEVE, FLANGED, SELF-LUBRICATING, -65 °F TO 325 °F
Nonlinear Time-Varying Dynamic Interactions of Hypoid Gear-Shaft-Bearing Systems
BEARING, BALL, AIRFRAME, ANTIFRICTION, INTERMEDIATE DUTY
BEARING, BALL, AIRFRAME ANTI-FRICTION, EXTRA WIDE DOUBLE ROW, INTERMEDIATE DUTY
BEARING, ROLLER, NEEDLE, TRACK ROLLER, INTEGRAL STUD, TYPE VII, ANTIFRICTION, INCH
Low Cost Robotized Gearshift System for Formula SAE Vehicles
BEARING, BALL, AIRFRAME, ANTI-FRICTION, EXTERNAL SELF-ALIGNING, EXTRA LIGHT DUTY
Predication & Correlation of Bearing Preload with Rotational Torque in Wheel End Bearing System
New Seven Speed DCT Transaxle and Effect of Angular Positioning of Shaft
An Analysis for Floating Bearings in a Turbocharger
A Study of Reliability Evaluation of Main Bearings for Multicylinder Diesel Engines
Design & Analysis of Bolt for Normal & Fracture Split Connecting Rod
Effect of Noise Factors on Seizure Limit Performance in Engine Main Bearings
Thermoplastic Bearings for Lubricated Applications
Life Estimation of Rolling Bearings Based on the Colors on Sliding Surfaces
Wear Properties of Car Engine Shaft in Actual Engine Environment
Plain Bearing Selection for Landing Gear Applications
A Study on Wear Progress of Plain Bearing under Mixed Lubrication Condition
Study on the Gear Meshing and Order Tracking of a Transfer Case
Power Loss Studies for Rolling Element Bearings Subject to Combined Radial and Axial Loading
Load Calculations for Three Roller Type Slew Ring Bearings
Study the Contact Geometry between the Clutch Release Bearing and the Clutch Fingers
Fault Feature Extraction of Elliptically Shaped Bearing Raceway
Analytical Evaluation of Impact Loads on Oscillating Rear Axle of Wheel Loaders
Gas Bubble Development in Connecting Rod Supply Systems Caused by Oil Aeration
The Effect of Outer Ring Flange Concavity on Automotive Wheel Bearings Performance
The Design of Low-Inertia, High-Speed External Gear Pump/Motors for Hydrostatic Dynamometer Systems
Cascaded position-flux controller for an AMB system operating at zero bias
Numerical Analysis of the Dynamic Behaviour of Axial Piston Pumps and Motors Slipper Bearings
The Potential of Variable Compressor Geometry for Highly Boosted Gasoline Engines
Investigations on Drive Axle Thermal Behaviour: Power Loss and Heat-Transfer Estimations
Plain Spherical Bearing Radial and Axial Clearance Measurement
Influence of Micro Geometry Modification on Gear Dynamics