Gearbox behavior is strictly affected by gears, shaft, bearings and casing stiffnesses. As a matter of fact, their contribution to gear dynamics is fundamental for mechanical transmissions design. In this paper a semi-analytical model developed for the estimation of the dynamic behavior of two mating gears is presented and tested on two case studies. Starting with the estimation of the Static Transmission Error, intended as the difference between the theoretical and actual angular position between the two mating gears, the dynamic behavior of the mating elements is estimated by means of a Dynamic Model. The Dynamic Model takes into account the gears, the contact between teeth exchanging loads and the other mechanical elements reduced by means of a DOF reduction technique. Based on the block-oriented approach, Dynamic Model allows the user to easily manage the complexity of the system with further or less elements by adding or removing DOFs. The outputs of the Dynamic Model are the Dynamic Transmission Error and the actual dynamic overload due to teeth mating. The main outputs of this model are the overloads in gear mating; such information is useful because the standards provide limited information about these parameters. In the present paper, two sets of gears are analyzed for testing the procedure and highlighting the advantages of the proposed technique. The gears are loaded at different torques, with increasing and decreasing spin speed and with different micro-geometrical teeth profile modifications (linear and parabolic tip relief, …). Spur gears are tested and an important focus on the effect of micro-geometry on the dynamic behavior of the system is shown. The technique is also useful for analyzing torque inversion events during working conditions.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Influence of Micro Geometry Modification on Gear Dynamics


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Rosso, Carlo (Autor:in) / Marcellini, Claudio (Autor:in) / Bruzzone, Fabio (Autor:in) / Maggi, Tommaso (Autor:in)

    Kongress:

    WCX SAE World Congress Experience ; 2020



    Erscheinungsdatum :

    2020-04-14




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Influence of Micro-Geometry on Gear Scuffing

    Ganti, V. / Dewangan, Y. / Arvariya, S. et al. | British Library Conference Proceedings | 2015


    Influence of Micro-Geometry on Gear Scuffing

    Arvariya, Saurabh / Madhavan, Shyamsananth / Ganti, Venu et al. | SAE Technical Papers | 2015


    Impact of gear finishing processes on micro geometry

    Kimme,S. / Bauer,R. / Drossel,W.G. et al. | Kraftfahrwesen | 2015


    Consideration of technology dependent deviations in designing gear micro geometry

    Boerner,J. / Zahnradfabrik Friedrichshafen,ZF,DE | Kraftfahrwesen | 2015


    The Development of Gear Tooth Micro Geometry Analysis Method for the Transmission Gear Noise Robustness

    Choi, Jae Hyuk / Lee, Hyun Ku / Suh, Hyun Seung et al. | British Library Conference Proceedings | 2019