The difficulties and expenses involved in field experiments on wheel-rail system wear forced researchers to use, whenever possible, laboratory tests. The major problem in laboratory tests is how to transfer the results obtained to the real wheel-rail system. Modeling of the the wear process between wheel flange and side face of a the rail head is studied and discussed. It is noted that the laboratory tests with rolling-lateral sliding better simulates wheel flange and rail head wear. Four wear modes, referred as mild, severe, heavy and catastrophic, have been identified in the laboratory tests. The heavy wear mode has not been identified before. The catastrophic wear mode has been observed at the lateral creepage of 5 %. The wear modes that occur in worn wheel flanges in side-worn rails have been found to correlate with those found on the rollers during laboratory tests. The boundaries of wear modes in terms of product of maximum contact pressure and creep value were defined. The hypothesis of wear mechanisms responsible for wear processes was suggested.
Wheel flange/rail head wear simulation
1998
7 Seiten, 7 Bilder, 4 Tabellen, 12 Quellen
Aufsatz (Zeitschrift)
Englisch
Engineering Index Backfile | 1903
|Method for measuring wear of rail-vehicle-wheel flange
Europäisches Patentamt | 2017
|METHOD FOR MEASURING WEAR OF RAIL-VEHICLE-WHEEL FLANGE
Europäisches Patentamt | 2016
|METHOD FOR MEASURING WEAR OF RAIL-VEHICLE-WHEEL FLANGE
Europäisches Patentamt | 2020
|Wear simulation in wheel flange-rail pair by rollers with lateral slippage
Tema Archiv | 1997
|