The objective of this study was to characterize the ES-2 head and neck response to lateral impacts at varying low magnitudes of impact velocities. A pendulum and mini sled were used to deliver inertial acceleration pulses to an isolated ES-2 head and neck. The base of the neck was attached to a cart which slid along the direction of impact from left to right on two precision ground rails. The shape of the cart acceleration was controlled by altering the momentum transfer of the pendulum. Eighteen tests were conducted at velocities ranging from 1.0 to 4.3 m/s. The head was instrumented with an internal nine accelerometer package to measure the linear and angular head accelerations. Upper and lower neck load cells measured the forces and moments. Cart and pendulum acceleration were measured from uniaxial accelerometers. All data was sampled at 20 kHz and filtered according to SAEJ211. A six-camera 1 kHz Vicon system measured the 3-d kinematics of retroreflective targets affixed to the head and neck. All forces and moments increased with velocity. Peak axial and shear forces at the upper and lower neck were similar, however moments at the lower neck were up to three times higher. The Head to T1 (Head-T1) and Head to Upper Spine (Head-US) angles were calculated from the marker position data. The Head-US angle plateaued at about 10° at the high velocity due to the physical constraints of the upper neck joint. Peak Head-T1 angle increased up to about 50° at the end velocity; however the overall percentage contribution of the Head-US angle to the Head-T1 angle decreased. The ES-2 head displayed a characteristic head lag that was demonstrated in Head-US angle and upper neck moment plots in velocities above 1.0 m/s which have also been reported in the human head neck complex studies. Matched paired tests with isolated Post Mortem Human Subjects are necessary to fully compare the ES-2 head and neck biofidelity.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    The EUROSID side impact dummy

    Kraftfahrwesen | 1985


    The thorax of the EUROSID Dummy

    Lowne,R.W. / Roberts,A.K. / Transport and Road Research Lab.,GB | Kraftfahrwesen | 1987


    A finite element model of the EUROSID dummy

    Rueckert,J. / Marcault,P. / Lasry,D. et al. | Kraftfahrwesen | 1992


    A Finite Element Model of the EUROSID Dummy

    Lasry, David / Cesari, Dominique / Haug, Eberhard et al. | SAE Technical Papers | 1992


    Biofidelity of the European Side Impact Dummy – EUROSID

    Vermissen, A. C. M. / Janssen, E. G. | SAE Technical Papers | 1988