More and more high strength steels have been developed to meet the progressive requirements from automotive industry in recent years. This tendency for steels to be of higher strength should coupled with the dissolve of the problems concerning with the ductility loss, fabrication complexity, cost increase, and service life deterioration due to strength level rising. The paper reviewed the recent scenario of automobile steels developed in CISRI. Four grades of hot stamping martensitic steels from 1500 MPa to 2200 MPa were developed through the improvement of ductility. A trial on nitrogen alloyed austenitic steel with high ductility was taken over to present a combination of high strength and high ductility. The study of high strength and high ductility in low and/or medium alloy steels gave the result of RmA approaching to 40 MPa% which could meet the requirement for the new generation sheet steel. The research on mechanisms of the delayed fracture and fatigue failure promoted the creation 1500 MPa grade bolt steel, 2000 MPa grade spring steel, and high strength case hardening steel. Non heat treated forging steel with less microalloying elements or without any microalloying element was developed through microstructure control to reduce the cost further. It is now generally believed that automotive steel is really a kind of new materials, which depends on market demands, steel metallurgy, production equipment and fundamental research. It is worthy to take more and more efforts on automotive steels to be of high performance in the near future.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The recent development of advanced automobile steel sheets and long products


    Weitere Titelangaben:

    Gegenwärtige Entwicklung moderner Autostahlbleche und Langerzeugnisse


    Beteiligte:
    Weng, Yuping (Autor:in) / Dong, Han (Autor:in) / Gan, Yong (Autor:in)


    Erscheinungsdatum :

    2009


    Format / Umfang :

    15 Seiten, 23 Bilder, 1 Tabelle, 29 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch






    Development of vibration damping steel sheets for automobile oil pans

    Murase, M. / Mukaihara, F. / Izawa, M. et al. | Tema Archiv | 1993


    Development of cold-rolled steel sheets for automobile outer panels

    Chou, T.S. / Hwang, Y.S. | Tema Archiv | 1994


    Development of Vibration Damping Steel Sheets for Automobile Oil Pans

    Mukaihara, Fuminori / Murase, Masatsugu / Izawa, Masazumi et al. | SAE Technical Papers | 1993