Aluminium alloys provide many benefits and challenges for use in marine environment. Attention on lightweight hulls leads to power saving, better handling and easy transportation. The stiffness and mass of the structure or member is responsible for its natural vibration. The hull panels and stiffeners vibrate at different frequencies when their stiffness is reduced by formation of a crack or any structural problems. If there is a monitoring system on board and by using a sensor detecting the modified vibrations, the maintenance crew senses the spot where urgent repair is needed. Application of composite laminates is convenient in view of portability and simplicity in procedure such as hand lay-up. In this study, the edge-cracked aluminium plates were repaired with one-sided composite patches and their temperature were varied to both low and high temperature levels. Dynamic fracture toughness was determined using Charpy impact test. Three different types of materials were used for composite patching: GFRP (glass-fibre-reinforced plastic), CFRP (carbon-fibre-reinforced plastic) and Kevlar. For each temperature level, two lay-ups were used, viz. three layered and five layered. Aluminium specimens with edge cracks of two different lengths, keeping the width of the crack constant, were prepared. Impact tests were performed for the prepared specimens at different temperatures. The fracture toughness of aluminium strips reinforced with patches was determined and compared with the energy absorbed during the impact of the corresponding specimen without the patch. It was observed that the specimen with patches gave a higher fracture toughness value when compared with that without the patch; corresponding observation on aluminium has been made along with patch at these temperatures. The patch using Kevlar was found to be the best among the three composites. Followed by these experiments, simulations using FRANC 2D software were carried out for finding stress intensity factor at different crack lengths with and without patches. The research has a spin-off application in the selection of materials used for patching and hence in the maintenance of LPG (liquefied petroleum gas) and LNG (liquefied natural gas) storage tanks under cryogenic conditions.
Dynamic fracture toughness of aluminium 6063 with multilayer composite patching at lower temperatures
Ships and Offshore Structures ; 8 , 2 ; 163-175
2013-04-01
13 pages
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
The use of patching to reinforce aluminium structures
Tema Archiv | 1988
|Cryogenic Fracture Toughness Testing of Aluminium 2195 Surface Cracks
British Library Conference Proceedings | 1994
|Cryogenic fracture toughness testing of aluminium 2195 surface cracks
Tema Archiv | 1994
|Patching Don't leave holes in your patching policies
British Library Online Contents | 2003