Abstract A new type approval procedure for determination of pollutants, CO2 emissions and fuel consumption was introduced in the EU and various other countries in 2017. The WLTP (Worldwide harmonized Light vehicles Test Procedures) can be used to determine the road load of a vehicle using the wind tunnel method instead of using coast down testing procedures on a proving ground. This method uses the measurement of the aerodynamic drag in a wind tunnel with the remaining components of the road load (mostly rolling resistance and drive train losses) determined by a flat belt or chassis dynamometer. This article investigates, whether it is possible to determine the road load in a wind tunnel as well. The AEROLAB wind tunnel of the BMW Group provides new possibilities which have not been previously investigated. This facility has a single-belt-rolling-road-system, which provides realistic flow conditions below the vehicle underbody and around the wheels. The aerodynamic forces are measured depending on ride height through a horizontal force measurement system in combination with a vehicle fixation at the front wheel hubs. The internal forces like rolling resistance and drive train losses are not be measured. However, with the integration of two other load cells in the vehicle fixation system, the internal forces of the vehicle can be determined in conjunction with the aerodynamic drag. The results and differences of these two measurement methods are discussed. In the following two sections of this chapter at first the reason for the introduction of WLTP and the assigning of the road load determination to the type approval procedure is shortly explained. The composition of the road load of a vehicle is stated in the second section.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Road load determination in a wind tunnel compared to the WLTP wind tunnel method


    Beteiligte:
    Vogeler, Isabell (Autor:in) / Untermaierhofer, R. (Autor:in) / Petz, R. (Autor:in) / Schütz, T. (Autor:in)


    Erscheinungsdatum :

    01.01.2018


    Format / Umfang :

    15 pages





    Medientyp :

    Aufsatz/Kapitel (Buch)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Different methods for road load determination in comparison — Wind tunnel, Wind tunnel method according to WLTP and Coastdown method

    Vogeler, I. / Untermaierhofer, R. / Petz, R. et al. | British Library Conference Proceedings | 2018


    FCA Full Scale Wind Tunnel: WLTP and Coast Down Test Performed With Wind Tunnel Method

    Betti, Luca / Stellato, Marco | SAE Technical Papers | 2018


    FCA Full Scale Wind Tunnel: WLTP and Coast Down Test Performed With Wind Tunnel Method

    Stellato, Marco / Betti, Luca | British Library Conference Proceedings | 2018


    Road Load Determination in a Wind Tunnel

    Vogeler, Isabell | DataCite | 2021

    Freier Zugriff

    Wind tunnel and on-road drag measurements compared

    Good, G.M. le / Passmore, M.A. | Tema Archiv | 1994