Roller tappets are commonly used in automotive valve trains to transform the rotational motion of the cam shaft into axial motion of the valves. Proper design of the cam and roller tappets requires an understanding of the factors that influence the integrity of the contact surfaces.Ideally the roller tappet to cam lobe contact should exhibit pure rolling (equal surface velocities). However, relative sliding (unequal surface velocities) occurs under most conditions. Relative sliding of contacting surfaces operating under marginal lubrication can contribute to deterioration of the surfaces. The relative sliding of tappet roller to cam has been experimentally determined by means of a simulator rig. Sophisticated instrumentation has been used to measure the velocities and synchronize them with the lift event. The experimental results showed high sliding during contact with the cam base circle (up to 20%). Sliding during the cam lift event was a maximum (up to 8%) during the periods of high linear acceleration and deceleration. Increased oil viscosity, reduced composite roughness and increased cam speed each resulted in increased skidding. Thrusting of the roller in an axial direction was also shown to increase roller sliding by as much as 100% on the base circle and 30% during the lift event. The experimental apparatus, test conditions and results are presented and discussed.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    An Experimental Investigation of Sliding at Cam to Roller Tappet Contacts


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Duffy, Paul E. (Autor:in)

    Kongress:

    International Congress & Exposition ; 1993



    Erscheinungsdatum :

    1993-03-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch


    Schlagwörter :


    An experimental investigation of sliding at cam to roller tappet contacts

    Duffy,P.E. / Torrington,US | Kraftfahrwesen | 1993


    Analysis of roller tappet behavior

    Kurata,M. / Igawashi,H. / Niino,S. et al. | Kraftfahrwesen | 1999


    Analysis of roller tappet behavior

    Kurata, Mashu | Online Contents | 1999


    Experimental evaluation of tappet/bore and cam/tappet friction for a direct acting bucket tappet valvetrain

    Pieprzak,J.M. / Willermet,P.A. / Dailey,D.P. et al. | Kraftfahrwesen | 1990


    Experimental Evaluation of Tappet/Bore and Cam/Tappet Friction for a Direct Acting Bucket Tappet Valvetrain

    Dailey, D. P. / Pieprzak, J. M. / Willermet, P. A. | SAE Technical Papers | 1990