Tappet/bore friction and torque at the camshaft were measured for a direct acting bucket tappet using a cam/tappet friction apparatus. Tappet/bore and cam/tappet friction torque and friction coefficient as a function of cam angle were derived from those measurements. The results showed that, for the particular geometry tested, tappet/bore friction torque accounted for about 13% of the total cam/tappet/bore friction torque at 250 cam rpm. This fraction decreased with increasing speed. Tappet bore friction was greatest at about ± 40 degrees of cam angle, where side loads on the tappet bore were highest. In contrast, earlier results for a center pivot rocker arm design showed tappet bore friction to be negligible.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Experimental Evaluation of Tappet/Bore and Cam/Tappet Friction for a Direct Acting Bucket Tappet Valvetrain


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Dailey, D. P. (Autor:in) / Pieprzak, J. M. (Autor:in) / Willermet, P. A. (Autor:in)

    Kongress:

    International Fuels & Lubricants Meeting & Exposition ; 1990



    Erscheinungsdatum :

    01.10.1990




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Experimental evaluation of tappet/bore and cam/tappet friction for a direct acting bucket tappet valvetrain

    Pieprzak,J.M. / Willermet,P.A. / Dailey,D.P. et al. | Kraftfahrwesen | 1990


    Dynamic Friction in Cam/Tappet Lubrication

    van Helden, A. K. / van Gelderen, E. / van Staaden, J. J. et al. | SAE Technical Papers | 1985


    Surface finish and composition dependence of valvetrain friction with silicon nitride tappet inserts

    Crosbie, G.M. / Allor, R.L. / Gangopadhyay, A. et al. | Tema Archiv | 1999


    Simple two-piece hydraulic tappet has bucket form

    Scott,D. / RIV-SKF,IT | Kraftfahrwesen | 1981


    The role of tappet surface morphology and metallurgy in cam/tappet life

    Smalley,R. / Gariglio,R. | Kraftfahrwesen | 1982