This paper reports visualization of behavior of spray, wall film, and initial flame propagation in an SI engine with port fuel injection system for motorcycle in order to directly investigate their influences on combustion and relations among them. Borescopes were used to visualize the flame propagation in the combustion chamber and wall film in the intake port. Various injection systems and injection parameters were tested: injection direction, timing, and size of droplets to investigate the effect of mixture formation. It is concluded that combustion stability under low load condition is greatly influenced by mixture inhomogeneity in the combustion chamber whose evidence is the luminous emission. It is caused by direct induction of considerable amount of liquid fuel with large size of droplets into combustion chamber or too inhomogeneous mixture in the intake port. Luminous emission in the flame was also seen under wide open throttle condition due to direct introduction of wall film into combustion chamber. Finally, great potential of highly atomized spray to keep combustion stability under low load condition and homogeneity under high load condition without defect of transient behavior due to wall film has been shown with injection timing of IVO.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Influence of Injection and Flame Propagation on Combustion in Motorcycle Engine - Investigation by Visualization Technique


    Beteiligte:


    Erscheinungsdatum :

    2011



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch



    The visualization and its analysis of combustion flame in a direct injection diesel engine

    Shiozaki,T. / Nakajima,H. / Yakota,H. et al. | Kraftfahrwesen | 1998


    Motorcycle intake air guide for a motorcycle internal combustion engine

    DUERMAIER FRITZ / HABLE DIETER | Europäisches Patentamt | 2021

    Freier Zugriff

    MOTORCYCLE INTERNAL COMBUSTION ENGINE COOLING DEVICE

    HAGIMURA MASAMI / SAKAUE MIKA / KANAI MASAKI et al. | Europäisches Patentamt | 2016

    Freier Zugriff