Thermal stresses have been evaluated in a nonmetallic gasket specimen by an experiment which employs a new thin foil stainless steel, compression resistant, heater of low heat capacity. Experimental results are predictable from a theoretically derived equation. An equation has also been derived for the thermal loads in a gasketed joint assembly. It considers the coefficients of linear expansion and stiffness coefficients for the bolt, gasket, and flange. The equation is discussed as a part of a rational engineering design procedure for calculating thermal loads in a joint assembly.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Thermal Loads in Gasketed Joints


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Smoley, E. M. (Autor:in) / Kessler, F. J. (Autor:in) / Kottmeyer, R. E. (Autor:in)

    Kongress:

    1968 Automotive Engineering Congress and Exposition ; 1968



    Erscheinungsdatum :

    01.02.1968




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Tightening Process Equipment Gasketed Joints Safely

    Staples, B. G. | SAE Technical Papers | 1977


    Effect of tightening speed on clamp load distribution in gasketed joints

    Nassar,S.A. / Alkelani,A.A. / Fastening and Joining Research Institute,Oakland Univ.,US | Kraftfahrwesen | 2006


    Effect of Tightening Speed on Clamp Load Distribution in Gasketed Joints

    Alkelani, Ali A. / Nassar, Sayed A. | SAE Technical Papers | 2006


    A Design/Analysis Method of Gasketed Bolted Joints for Noise/Vibration Control

    Novak, Gary / Zwick, James R. / Hu, Zhi Quan | SAE Technical Papers | 1995


    A design/analysis method of gasketed bolted joints for noise/vibration control

    Zwick,J.R. / Hu,Z.Q. / Novak,G. et al. | Kraftfahrwesen | 1995