Torque versus load measurements were conducted on SA-193, Grade B-7 bolts to establish friction characteristics under dry and lubricated conditions, using strain gages with appropriate read-out. Similar torque-load ratio figures were obtained for a series of different size clamps, employing a Tinius-Olsen tensile testing machine for which suitable fixtures were designed and constructed.With the data produced from these investigation and projected failure loads, it was possible to establish maximum torque limits which would fall within predetermined safety requirements. The equipment used in this investigation is explained and the calculations discussed.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Tightening Process Equipment Gasketed Joints Safely


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Staples, B. G. (Autor:in)

    Kongress:

    1977 International Automotive Engineering Congress and Exposition ; 1977



    Erscheinungsdatum :

    1977-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Effect of tightening speed on clamp load distribution in gasketed joints

    Nassar,S.A. / Alkelani,A.A. / Fastening and Joining Research Institute,Oakland Univ.,US | Kraftfahrwesen | 2006


    Effect of Tightening Speed on Clamp Load Distribution in Gasketed Joints

    Alkelani, Ali A. / Nassar, Sayed A. | SAE Technical Papers | 2006


    Thermal Loads in Gasketed Joints

    Smoley, E. M. / Kessler, F. J. / Kottmeyer, R. E. | SAE Technical Papers | 1968



    A Design/Analysis Method of Gasketed Bolted Joints for Noise/Vibration Control

    Novak, Gary / Zwick, James R. / Hu, Zhi Quan | SAE Technical Papers | 1995