This paper describes a newly developed steel composition and surface modification methods for improving the rolling contact fatigue strength of parts used in transmission systems, especially continuously variable transmissions (CVTs) to increase their torque capacity.The mechanisms of two types of typical rolling contact fatigue phenomenon in case hardening steel were examined with the aim of improving rolling contact fatigue strength. One concerned white etching constituents (WEC) and the other one concerned peculiar microstructural changes caused by hydrogen originating from decomposition of the lubrication oil as a result of repeated rolling contact stress cycles.The rolling contact fatigue strength limit due to WEC has been improved markedly by dispersing fine M23C6 alloy carbides in the martensite matrix at the subsurface layer of parts. The parts are produced by the combination of an alloy design with Cr and Mo and an additional heat treatment and strengthening of the matrix by alloying Si and Ni. The rolling contact fatigue strength limit due to hydrogen has been improved by inhibiting hydrogen invasion with Ni plating as a hydrogen barrier.
Research on High Strength Material and Its Surface Modification for Parts Used Under Rolling Contact Cycles
Sae Technical Papers
SAE 2004 World Congress & Exhibition ; 2004
2004-03-08
Aufsatz (Konferenz)
Englisch
British Library Conference Proceedings | 2004
|The Rolling Contact Fatigue Property of Powder Forged Parts
Kraftfahrwesen | 1987
|The Rolling Contact Fatigue Property of Powder Forged Parts
SAE Technical Papers | 1987
|Rolling contact fatigue in railway wheels under high axle loads
Tema Archiv | 1991
|