The effectiveness of after-treatment systems depends on the exhaust gas temperature, which is low during cold-start. As a result, Euro III, Euro IV and FTP75 require that the emissions tests include exhaust from the beginning of cold start. It is proved that 50%∼80% of HC and CO emissions are emitted during the cold start and the amount of unburned fuel from the crevices during starting is much higher than that under warmed engine conditions. The piston crevices is the most part of combustion chamber crevices, and results of mathematical simulations show that the piston crevice contribution to HC emissions is expected to increase during cold engine operation.Based on the transient HC test data and the double zone combustion model, this paper presents the study of the crevice HC Mechanism of the first firing cycle at cold start on an LPG SI Engine. A fast-response flame ionization detector (FFID) was employed to measure transient HC emissions of the first firing cycle. At the same time, the transient cylinder pressure and instantaneous crankshaft speed of the engine were measured and recorded. Based on the transient HC test data and the double zone combustion model, the crevice HC mechanism model was set up. The cylinder pressure of the combustion simulation has a good relation with the test data, and the crevice HC model is proved by the comparison between the simulation and the test results. By the simulation, it is found that the HC mole concentration in the crevice at the peak cylinder pressure time has a great effect on the HC emissions for the first firing cycle.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A Study of Crevice HC Mechanism Based on the Transient HC Test Data and the Double Zone Combustion Model


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Qiu, Dongping (Autor:in) / Li, Gong (Autor:in) / Li, Liguang (Autor:in)

    Kongress:

    2008 SAE International Powertrains, Fuels and Lubricants Congress ; 2008



    Erscheinungsdatum :

    2008-06-23




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    A Study of Crevice HC Mechanism Based on the Transient HC Test Data and the Double Zone Combustion Model

    Li, L. / Li, G. / Qiu, D. et al. | British Library Conference Proceedings | 2008


    Piston-Liner Crevice Geometry Effect on HCCI Combustion by Multi-Zone Analysis

    Johansson, Bengt / Flowers, Daniel L. / Espinosa-Loza, Francisco et al. | SAE Technical Papers | 2002


    Piston-liner crevice geometry effect on HCCI combustion by multi-zone analysis

    Aceves,S.M. / Flowers,D.L. / Espinosa-Loza,F. et al. | Kraftfahrwesen | 2002


    Mechanism of dissimilar metal crevice corrosion of superferritic stainless steels

    Salamat, G. / Juhl, G.A. / Kelly, R.G. | Tema Archiv | 1995