This paper describes the methods taken to effect a step change in passenger car bumper design in order to meet Federal Standard 215, set forth by the Department of Transportation. The basic goal is to achieve a lightweight, low-cost bumper that is compatible with styling and durable enough to suffer little or no damage during impact at 5 mph (8 km/h).Three major areas-bumper design, materials, and fabrication-are treated separately and also as they interrelate. Boxlike sections, utilizing the face bar as an integral stressed member and judiciously employing beads and gussets, give best strength and stiffness Materials should be of highest yield strength compatible with formability, and welded or bonded fabrication, approaching one-piece box construction, results in optimum structural properties.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Bumper Design, Materials, and Fabrication


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Kienle, R. F. (Autor:in) / Golze, R. R. (Autor:in)

    Kongress:

    1973 International Automotive Engineering Congress and Exposition ; 1973



    Erscheinungsdatum :

    1973-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    BUMPER BRIDGE, BUMPER ASSEMBLY COMPRISING SAME, AND FABRICATION THEREOF

    ALTUNCAN HAKAN / MARTIN THIERRY / GUNS KOEN | Europäisches Patentamt | 2020

    Freier Zugriff

    Bumper Systems and Materials

    T. Tomita | NTIS | 1988


    Resilient bumper and bumper system

    KHODR RABIH A | Europäisches Patentamt | 2023

    Freier Zugriff

    Resilient Bumper and Bumper System

    KHODR RABIH A | Europäisches Patentamt | 2022

    Freier Zugriff

    BUMPER

    HULTKVIST JAKOB | Europäisches Patentamt | 2022

    Freier Zugriff