This paper proposes two new methods for the identification of static stiffnesses of multi degrees of freedom heavy industrial robots. They are based on a locked link joint procedure obtained with an end-effector fixed to the environment. The first method requires only measurements of motor positions and motor torques data computed from motor current measurements and manufacturer's drive gains. The second one needs a torque sensor to measure the interaction wrench between the clamped end-effector and the environment. These methods are being experimentally validated and compared on the 2 first joints of a 6 degrees of freedom heavy 500Kg payload industrial Kuka KR500 robot.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Joint stiffness identification of a heavy Kuka robot with a low-cost clamped end-effector procedure


    Beteiligte:
    Jubien, A. (Autor:in) / Abba, G. (Autor:in) / Gautier, M. (Autor:in)


    Erscheinungsdatum :

    01.09.2014


    Format / Umfang :

    660589 byte



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch