THE primary consideration in establishing a set of limits for use in the manufacture of any engineering product must always be closely related to the quantity of parts, or units, to be produced. Thus, the component parts of a motor car will be produced in quantities which warrant the manufacture of expensive jigs and tools, these being made to a precision, where demanded, far beyond that to be expected for parts which are other than mass produced. Diametrically opposite to this we have the case of an experimental aircraft, or similar engineering project, which will be produced to limits which are dependent upon the skill of the operatives in making the component parts without the aid of jigs, templates, etc.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Manufacturing Tolerances


    Beteiligte:
    Parkinson, H. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    01.04.1939


    Format / Umfang :

    2 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Manufacturing tolerances

    Parkinson, H. | Engineering Index Backfile | 1939


    Influence of manufacturing tolerances

    Timcke, Jürgen | Online Contents | 1994


    Including manufacturing tolerances in composite design

    Kristinsdottir, B. / Zabinsky, Z. | AIAA | 1994


    Manufacturing tolerances and axle system NVH performance

    Sun, Zhaohui / Ranek, Mark / Voight, Michael et al. | Tema Archiv | 2006


    Forging tolerances

    Conway, H.G. | Engineering Index Backfile | 1953