Development of design and fabrication procedures required to replace existing aluminum section of wing structure with part made of boron-epoxy; wing box extension was selected as component because it incorporates many of problems associated with aircraft structures such as access covers, control surface mountings, contoured surfaces, and fuel pressurization including variety of loads and environmental conditions involved; although existing aluminum design is unpressurized, demonstration component has been designed to include pressurized cell to demonstrate feasibility of building integral fuel tank; test data and specimens, design philosophy used, and specific weight-strength comparisons with typical aircraft materials are presented.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Design and fabrication of pressurized boron composite wing box


    Weitere Titelangaben:

    SAE -- Paper


    Beteiligte:
    August, A. (Autor:in) / Hadcock, R. (Autor:in) / Ludwig, W. (Autor:in)

    Kongress:

    SAE Meeting ; 1968 Plastics



    Erscheinungsdatum :

    1968


    Format / Umfang :

    9 pages


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch


    Schlagwörter :


    Design and Fabrication of a Pressurized Boron Composite Wing Box

    August, A. / Hadcock, R. / Ludwig, W. | SAE Technical Papers | 1968



    Pressurized Morphing Wing Structures

    Vasista, S. / Tong, L. / American Institute of Aeronautics and Astronautics | British Library Conference Proceedings | 2012


    Pressurized Morphing Wing Structures

    Vasista, Srinivas / Tong, Liyong | AIAA | 2012