In order to provide the relatively accurate experimental basis for optimizing parameters and controlling surface metamorphic layer, ball end high-speed milling experiments of TC17 titanium alloy were carried out utilizing one of experimental design techniques based on the response surface methodology. The surface roughness prediction model was built, variance analyses were applied to check the significances of surface roughness model and input parameters, the effect of parameters on surface roughness was analyzed. Meanwhile, the residual stress, microhardness and microstructure under the condition of high, medium and low level of parameters were investigated. Results indicate that the model can predict the surface roughness effectively and feed per tooth and radial depth of cut have an obvious effect on surface roughness. Compressive residual stresses are detected on all milled surfaces and surface residual stresses are increased with the increase of the level of the milling parameters. The compressive residual stress layer is approximately 20 μm regardless of milling parameters level used. The process of thermal softening, then work hardening, and finally tending to stabilize are observed in the microhardness profiles. Grains of the surface layer are broken and bent, the thickness of plastic deformation layer is approximately 10 μm.


    Zugriff

    Download


    Exportieren, teilen und zitieren



    Titel :

    Effect of High-Speed Milling Parameters on Surface Metamorphic Layer of TC17 Titanium Alloy


    Beteiligte:
    TAN Liang (Autor:in) / ZHANG Dinghua (Autor:in) / YAO Changfeng (Autor:in)


    Erscheinungsdatum :

    2017




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Unbekannt




    Effect of Cold Expansion on Fatigue Life of Hole Structure of TC17 Titanium Alloy

    AI Yingjun / WANG Xin / SONG Yinggang et al. | DOAJ | 2017

    Freier Zugriff

    Numerical Simulation of TC17 Titanium Alloy Thin Blade Strengthened by Laser Shock Processing

    Ma, Sijie / Ding, Xiangyu / Yang, Zhi et al. | Springer Verlag | 2022



    Effect of strain rate on mechanical properties of TC17 and TC4 alloy forgings

    CHEN Yuhao / MIN Xiaohua / ZHANG Haiyang et al. | DOAJ | 2023

    Freier Zugriff

    WEAR MECHANISMS AND PERFORMANCE OF COATED INSERTS DURING FACE MILLING OF TC11 AND TC17 ALLOYS

    Niu, Qiulin / An, Qinglong / Chen, Ming et al. | British Library Online Contents | 2013