Many major issues occur from material failure, and Six Sigma presents a solution to those problems caused by poor production quality. Investigating and eliminating the causes of defects can improve the quality of the finished product and boost the productivity and profitability of a company. The objectives of this research are to improve product quality based on the lean Six Sigma methodology for the plastic injection moulding process. Following the Six Sigma steps of define, measure, analysis, improvement and control, many defects can be identified and avoided using an experimental method. Defects on plastic injection moulding products include flash defects, warpage and sink marks. An experiment was conducted to determine the optimal injection moulding process parameters at 31.79 MPa strength that could meet the yield strength standard. The Six Sigma method was proven to improve the quality of products manufactured in the plastics industry.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Six sigma methodology for dog bone product of plastic injection moulding process improvement


    Beteiligte:
    Majid, Mohd Adli Abd (Autor:in) / Yahaya, Mohd Arbain Mohd (Autor:in) / Yusoff, Ahmad Razlan (Autor:in) / Ramasamy, Devarajan (Herausgeber:in) / Kadirgama, Kumaran (Herausgeber:in) / Mohamed, Zamri (Herausgeber:in) / Norsat, Rosidah Mohd (Herausgeber:in)

    Kongress:

    THE 5TH INTERNATIONAL CONFERENCE ON AUTOMOTIVE INNOVATION AND GREEN ENERGY VEHICLE ; 2022 ; Pahang, Malaysia


    Erschienen in:

    Erscheinungsdatum :

    11.03.2024


    Format / Umfang :

    6 pages





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    INJECTION MOULDING PROCESS AND INJECTION MOULD

    FIAMMENGO FABIO | Europäisches Patentamt | 2016

    Freier Zugriff

    INJECTION MOULDING SYSTEM AND INJECTION MOULDING METHOD

    BEN HORIN AMITAI | Europäisches Patentamt | 2022

    Freier Zugriff

    Application of computer simulation to injection moulding of automotive plastic parts

    Ugi, H. / Kogishi, M. / Fukuoga, K. et al. | Tema Archiv | 1992


    Application of computer simulation to injection moulding of automotive plastic parts

    Ugi,H. / Kogishi,M. / Fukuoga,K. et al. | Kraftfahrwesen | 1992


    Gas Injection Moulding - The Process and Case Study

    Knight, A. / SPE | British Library Conference Proceedings | 1995