Within the scope of the SARISTU project (smart intelligent aircraft structures), a wingtip active trailing edge (WATE) is developed. Winglets are intended to improve the aircraft’s efficiency aerodynamically, but simultaneously they introduce important loads into the main wing structure. These additional loads lead to heavier wing structure and can thus diminish the initial benefit. Preliminary investigations have shown that a wingtip active trailing edge can significantly reduce these loads at critical flight points (active load alleviation). Additionally, it can provide adapted winglet geometry in off-design flight conditions to further improve aerodynamic efficiency. The idea of the active winglet has been successfully treated in several theoretical studies and small-scale experiments. However, there is a big step towards bringing this concept to a real flight application. In this project, a full-scale outer wing and winglet are currently being manufactured and will be tested, both structurally and at low speed in a wind tunnel. The scope for eventual EASA CS25 certification of a civil transport aircraft with such a winglet control device will then be assessed. In particular, a load alleviation system requires a minimum operational reliability to take effect on the applicable flight load envelope for structural design. Therefore, the potential failure modes are assessed, and a fault tree analysis is performed to draw key requirements for the system architecture design. In order to assess the overall system benefit, manufacturing, operation, and maintenance requirements are taken into account. The confined space inside the winglet loft-line presents a significant challenge for integration of an active control system. It is shown how small changes to the aerodynamic surface have both reduced the aerodynamic hinge moments (leading to lighter actuators) and created additional internal space for systems, whilst maintaining an equivalent overall drag level. The potential for reducing wing and winglet loads with a winglet control device is assessed. The kinematic design challenge of delivering the necessary power in a confined space is described. Actuation is accomplished by a single electromechanical actuator which is housed inside the CFRP winglet.


    Access

    Check access

    Check availability in my library

    Order at Subito €


    Export, share and cite



    Title :

    Design, Optimization, Testing, Verification, and Validation of the Wingtip Active Trailing Edge



    Published in:

    Publication date :

    2015-09-05


    Size :

    37 pages




    Type of media :

    Article/Chapter (Book)


    Type of material :

    Electronic Resource


    Language :

    English




    Trailing Vortex Strength Attenuation via Chipped Wingtip Shapes

    Jin, J. / Yee, K. / Oh, S. et al. | British Library Conference Proceedings | 2013


    Trailing Vortex Strength Attenuation via Chipped Wingtip Shapes

    Jin, Junghyun / Yee, Kwanjung / Oh, Sejong | AIAA | 2013


    CFD-Based Evaluation of Wingtip Device by Trailing Edge Curve Variation on Low Reynolds UAV

    Fam, Jonwin Fidelis / Thomas, William Nathan / Faathira, Dhiyaa Al Dien et al. | IEEE | 2023


    Verification and Validation of LES for Interaction of Wingtip Vortex and Wakes

    Cai, Jiangang / Wei, Hua / Oliveira, Maria et al. | AIAA | 2008


    Verification and Validation of LES for Interaction of Wingtip Vortex and Wakes

    Cai, J. / Wei, H. / Oliveira, M. et al. | British Library Conference Proceedings | 2008