Development of commercial supersonic aircraft has been hindered by many related factors including fuel-efficiency, economics, and sonic-boom signatures that have prevented over-land flight. Materials, propulsion, and flight control technologies have developed to the point where, if over-land flight were made possible, a commercial supersonic transport could be economically viable. Computational fluid dynamics, and modern optimization techniques enable designers to reduce the boom signature of candidate aircraft configurations to acceptable levels. However, propulsion systems must be carefully integrated with these low-boom configurations in order that the signatures remain acceptable. One technique to minimize the downward propagation of waves is to mount the propulsion systems above the wing, such that the wing provides shielding from shock waves generated by the inlet and nacelle. This topmounted approach introduces a number of issues with inlet design and performance especially with the highly-swept wing configurations common to low-boom designs. A 1.79%-scale aircraft model was built and tested at the NASA Glenn Research Center's 8-by 6-Foot Supersonic Wind Tunnel (8x6 SWT) to validate the configuration's sonic boom signature. In order to evaluate performance of the top-mounted inlets, the starboard flow-through nacelle on the aerodynamic model was replaced by a 2.3%-scale operational inlet model. This integrated configuration was tested at the 8x6 SWT from Mach 0.25 to 1.8 over a wide range of angles-of-attack and yaw. The inlet was also tested in an isolated configuration over a smaller range of angles-of-attack and yaw. A number of boundary-layer bleed configurations were investigated and found to provide a substantial positive impact on pressure recovery and distortion. Installed inlet performance in terms of mass capture, pressure recovery, and distortion over the Mach number range at the design angle-of-attack of 4-degrees is presented herein and compared to that at 0- degrees, as well as the isolated inlet configuration to highlight installation effects. Performance of the installed inlet fell below that of the isolated inlet at Mach numbers of 1.4 and greater. The installed inlet demonstrated adequate operability over the expected range of angles-of-attack and yaw, but did exhibit definite angle-ofattack and yaw limits at supersonic conditions. At each supersonic flight Mach number, performance parameters near zero yaw angle were relatively insensitive to yaw, but in general the yaw angle yielding best performance was non-zero and varied with angle-of-attack. Performance of the installed inlet is also presented as functions of angle-of-attack and yaw to highlight these effects. Distortion at the aerodynamic interface plane ranged between 10 and 25% at the inlet critical points over the range of flight Mach numbers tested and did not decrease significantly for the isolated inlet. Although these distortion levels would be considered high for operation with a turbine engine, the over-wing installation is likely not as significant a contributor as the low test Reynolds number. This is demonstrated by comparing CFD analysis of the isolated inlet at test scale with that at intermediate and full scales.


    Access

    Access via TIB

    Check availability in my library


    Export, share and cite



    Title :

    Performance of a Supersonic Over-Wing Inlet with Application to a Low-Sonic-Boom Aircraft


    Contributors:
    C. J. Trefny (author) / S. M. Hirt (author) / B. H. Anderson (author) / L. E. Fink (author) / T. E. Magee (author)

    Publication date :

    2014


    Size :

    30 pages


    Type of media :

    Report


    Type of material :

    No indication


    Language :

    English




    Performance of a Supersonic Over-Wing Inlet with Application to a Low-Sonic-Boom Aircraft

    Trefny, Charles J. / Hirt, Stefanie M. / Anderson, Bernhard H. et al. | NTRS | 2014


    Sonic boom -- Limitations on supersonic aircraft operations

    Patterson, D.W. | Engineering Index Backfile | 1960


    SUPERSONIC AIRCRAFT AND SONIC BOOM REDUCTION METHOD

    UENO ATSUSHI / YUHARA TATSUNORI / KANAMORI MASASHI | European Patent Office | 2019

    Free access

    Sonic boom impact on the supersonic aircraft design

    Balis Crema, L. / Castellani, A. / East-European Acoustical Association | British Library Conference Proceedings | 1994


    MULTI-FIDELITY SONIC BOOM MINIMIZATION OF A SUPERSONIC AIRCRAFT BY PARAMETRIC WING SHAPE DESIGN

    Demiroglu, Yusuf / Yildiz, Sihmehmet / Nikbay, Melike | TIBKAT | 2021