1–20 von 144 Ergebnissen
|

    International Astronautical Congress

    Engineering Index Backfile | 1959
    German); Optimum Design of Solid Propellant Power-Plants for Missiles Systems Engineering, J.A.VANDENK ERCKHOVE, 148-67; On Class of Compressible ...

    An Automated Air Cargo Terminal, Theory and Concept

    McKenna, M. L. | SAE Technical Papers | 1964
    automation, (3) time sharing (a basis of design), (4) terminal facility requirements, and (5) payback.Based on knowledge and experience gained in ...
    Verlag: Society of Automotive Engineers , SAE International

    Influence of Lubricating Oil Formulation on Winter Hot-Starting Engine Torque Requirements

    Spohn, C. R. / Stewart, R. M. / Meyer, W. A. P. | SAE Technical Papers | 1969
    The influence of lubricating oil formulation on the winter hot-starting torque requirements of an automotive engine was investigated in a ...
    Verlag: Society of Automotive Engineers , SAE International

    International Efforts to Control Radio Spectrum Pollution from Motor Vehicles

    Bauer, F. | SAE Technical Papers | 1973
    recently accelerated and broadened in scope. The U.S. automotive industry is affected principally by international legislative restrictions on ...
    Verlag: Society of Automotive Engineers , SAE International

    Reduction of Emissions from Diesel Engines

    Walder, C. J. | SAE Technical Papers | 1973
    examination of many forms of combustion chambers in search for a solution to the 5 g/bhp·h combined HC + NO2 requirement. Results of tests made on ...
    Verlag: Society of Automotive Engineers , SAE International

    Automotive Organic Rankine-Cycle Powerplant - Design and Performance Data

    Doyle, E. F. / Patel, P. / Sakhuja, R. et al. | SAE Technical Papers | 1974
    could meet the 1976 emission standards specified by Congress in the 1970 Clean Air Act. Performance and fuel consumption predictions are ...
    Verlag: Society of Automotive Engineers , SAE International

    Programmable Energy Ignition System For Engine Optimization

    Neuman, John G. / Agarwal, Paul D. / Johnston, Richard W. | SAE Technical Papers | 1975
    Emission control requirements have prompted optimization studies of many engine parameters, such as engine geometry, fuel preparation, and ...
    Verlag: Society of Automotive Engineers , SAE International

    Structural Design Considerations for Aluminum Bumpers

    Sharp, M. L. / Weiss, R. B. / Peters, R. M. | SAE Technical Papers | 1977
    The 1980 requirements for bumpers limit the damage that may be sustained in 8 km/h (5 mph) pendulum and barrier impacts. This paper covers ...
    Verlag: Society of Automotive Engineers , SAE International

    Thermal and Catalytic Regeneration of Diesel Particulate Traps

    Cikanek, H. A. / White, J. E. / Florek, J. J. et al. | SAE Technical Papers | 1983
    durability and control system requirements were identified. In the catalytic technique, Diesel fuel containing .5 gm/gal lead and .25 gm/gal copper ...
    Verlag: Society of Automotive Engineers , SAE International

    System level approach for automotive electromagnetic compatibility

    Sultan, M.F. / Cangellaris, A.C. | Tema Archiv | 1987
    This paper outlines a system level numerical technique to address automotive electromagnetic compatibility (EMC) problems. The number of ...

    AEDC's facility computer enhancement project

    Bond, D.C. / Cogburn, J.L. | Tema Archiv | 1987
    The Arnold Engineering Development Center (AEDC) constitutes the largest collection of test cells, wind tunnels, altitude chambers, and ...

    The systems design approach (better late than not at all)

    Gormley, J. / Mac Isaac, D.A. | Tema Archiv | 1988
    result of a grouping of optimized components. The systems process begins with a complete definition of the system requirements, is followed by ...

    A fast and low-cost validation technique for ILS and MLS

    Mahapatra, P.R. / Poulose, M.M. | Tema Archiv | 1990
    conditions and also reduce computational requirements to a minimum. The result is a scheme that can be used to evaluate most terrain types on a mini ...

    Hinfinity design of future flight control systems

    Colgren, R. | Tema Archiv | 1990
    The Hinfinity design technique outlined is used to develop flight control laws for a control configured vehicle. The dynamics of ...
    Verlag: IEEE Comput. Soc. Press , Los Alamitos
    Schlagwörter: CLOSED-LOOP PERFORMANCE REQUIREMENTS

    Joint Conference on Marine Safety and Environment/Ship Production (1st), held 1-5 June 1992

    NTIS | 1992
    . Without ships international business would be impossible at the scale of today, e.g. in the E.C. more than 65% of the cargo is carried by seagoing ...
    Schlagwörter: Marine Engineering , Symposia

    Brake and Clutch Pedal System Optimization Using Design for Manufacture and Assembly

    Ardayfio, David D. / Opra, John J. | SAE Technical Papers | 1992
    This paper describes the application of the Design for Manufacture and Assembly (DFMA) method at Chrysler. Attention is focused on the ...
    Verlag: Society of Automotive Engineers , SAE International

    Multidimensional Port-and-Cylinder Gas Flow, Fuel Spray, and Combustion Calculations for a Port-Fuel-Injection Engine

    Kuo, Tang-Wei | SAE Technical Papers | 1992
    calculations in a port-fuel-injection engine. The effect of a moving valve with a stem was modeled using a novel internal obstacle technique in which ...
    Verlag: Society of Automotive Engineers , SAE International

    System performance of vehicle-roadside communications using asynchronous and synchronous MAC protocols

    Wietfeld, C. | Tema Archiv | 1994
    , choices between several options are made on the basis of performance evaluations. In this paper, the results of a performance evaluation of VRC ...

    RAM related performances of high speed railway multivoltage vehicles: a probabilistic approach based on stochastic reward nets

    Cosulich, G. / Firpo, P. / Savio, S. et al. | British Library Conference Proceedings | 1995
    Schlagwörter: electric power engineering , IEEE , power engineering

    High NOx reduction system mounted on 500 GT class vessel

    Yaguchi, K. / Yoshida, T. / Sato, K. et al. | Tema Archiv | 1995
    requirements for land and marine applications; Element tests for marine application; On-board performance and control tests at sea. These examinations ...