Synonyme wurden verwendet für: Verformung
Suche ohne Synonyme: keywords:("Verformung")

101–150 von 1,758 Ergebnissen
|

    Research on Geometry Model and Stress State Leading-In through Heavy Rail Cooling to Compound Straightening

    Song, Hua / Yao, Jin-Kai / Li, Kui-Xing et al. | Tema Archiv | 2013
    Schlagwörter: Verformung

    Crash zone development for railway vehicle

    Puja, I.W. / Weij, S. | Tema Archiv | 2006
    Schlagwörter: plastische Verformung

    Seasonal vertical crustal motions in China detected by GPS

    Zhang, F. P. / Cheng, Z. Y. / Cheng, M. K. et al. | NTRS | 2002
    Schlagwörter: GPS crustal deformation

    An investigation to the influence of bogie direction reversal on equalizing rail vehicle wheel wear

    Lari, Ali Asadi / Kapoor, Ajay | Tema Archiv | 2008
    Schlagwörter: Verformung unter Last

    Sub-modelling for the ratchetting failure of insulated rail joints

    Mandal, Nirmal Kumar / Dhanasekar, M. | Tema Archiv | 2013
    Schlagwörter: plastische Verformung

    Investigation of deep drawing of the side car body panels

    Del, G.D. / Voropaev, A.A. / Tolstov, S.A. | Tema Archiv | 1993
    Schlagwörter: Verformung

    Identification of coupled solution spaces for vehicle crash structure and restraint system design

    Lange, Volker Andreas / Technische Universität München / Shaker Verlag | TIBKAT | 2021
    Schlagwörter: Deformation

    Review of data relevant to the design of tubular joints for use in fixed offshore platforms - Chapter IV: Displacements

    Rodabaugh, E.C. | Tema Archiv | 1980
    Schlagwörter: ELASTISCHE VERFORMUNG , PLASTISCHE VERFORMUNG

    Effects of anti-recirculation ring on performance of an automotive cooling fan

    Chen, Q.G. / Zhang, Y.C. / Li, F. et al. | Tema Archiv | 2013
    Schlagwörter: einachsige Verformung

    Anforderungsgerechte Fertigung. Dünnwandige gegossene Aluminium-Prototypen und Kleinserien im Karosseriebau

    Gundlach, Joachim / Detering, Jörg | Tema Archiv | 2011
    Schlagwörter: Verzug (Verformung)

    Deformation behavior of Al-Mg-Si alloy at the elevated temperature

    Kwon, Y.N. / Lee, Y.S. / Lee, J.H. | Tema Archiv | 2007
    Schlagwörter: Verformung

    Tunnelling for the third section of the Stadtbahn line U12 in Stuttgart

    Gradnik, Richard / Kicherer, Manfred / Zwick, Markus | Tema Archiv | 2014
    Schlagwörter: Verformung

    The importance of alignment for an engine builder

    Schiffer, Wilfried | Tema Archiv | 2007
    Schlagwörter: Verformung

    Research on the crashworthy structures of subway vehicles

    Xie, Suchao / Zhou, Hui | Tema Archiv | 2014
    Schlagwörter: plastische Deformation

    On the displacement formulation of torsion of shafts with rectangular cross-sections

    Bathe, K.J. / Chaudhary, A. | Tema Archiv | 1982
    Schlagwörter: VERFORMUNG

    Finite element simulation of deformation behavior in friction welding of Al-Cu-Mg alloy

    Li, Qinghua / Li, Fuguo / Li, Miaoquan et al. | Tema Archiv | 2006
    Schlagwörter: plastische Verformung , Verformung unter Last

    Structural behavior of dented tubular members under lateral loads

    Ruggieri, Claudio / Ferrari, Jose Alfredo jun. | Tema Archiv | 2004
    Schlagwörter: plastische Verformung

    Finishing method of forming spring leaves

    Muratkin, G.V. | Tema Archiv | 2013
    Schlagwörter: plastische Verformung

    Characterisation of plastic deformation and thermal softening of the surface layer of railway passenger wheel treads

    Cvetkovski, K. / Ahlström, J. | Tema Archiv | 2013
    Schlagwörter: starke plastische Verformung , plastische Deformation

    Minimizing the error signal of automotive pressure sensors using Finite-Element-Analysis and automated optimisation

    Karst, Dieter / Cavalloni, Claudio / Büche, Dirk et al. | Tema Archiv | 2007
    Schlagwörter: Verformung , thermische Verformung

    Bestimmung von Getriebeverformungen und Flankenrichtungskorrekturen mehrstufiger Zahnradgetriebe

    Weck, Manfred / Gold, Peter / Goebbelet, Josef | TIBKAT | 1977
    Schlagwörter: Deformation

    Entstehung von Gleisbettwellen

    Kreibich, Rolf; Nolte, Roland | IuD Bahn | 1999
    Schlagwörter: Verformung

    Badania zmeczeniowe stopu AlZnMgCu przeznaczonego na elementy zawieszenia

    Maj, M. / Pysz, S. / Pieklo, J. et al. | Tema Archiv | 2012
    Schlagwörter: plastische Verformung

    New method sets concrete coating's effect on pipeline stiffness, stress

    Aynbinder, Alexander | Tema Archiv | 2006
    Schlagwörter: Verformung

    Elastic and dynamic clearance analysis in commercial vehicle development

    Meijnikov, Darko / Link, Dieter / Reif, David | Tema Archiv | 2011
    Schlagwörter: elastische Verformung

    Determination of parameters of adjustment of process of creation of a preliminary tightness of bearings in units of machines

    Bulavin, I.A. / Gruzdev, A.Y. / Budykin, A.V. | Tema Archiv | 2013
    Schlagwörter: Verformung

    Systemleichtbau am Beispiel eines Reisemobilchassis

    Diel, S. / Pöschl, M. / Huber, O. | Tema Archiv | 2013
    Schlagwörter: Verformung

    Experimental investigations of prebuckled cylinders under external pressure

    Knapp, R.H. / Dumlao, C. | Tema Archiv | 1978
    Schlagwörter: VERFORMUNG

    designs for safety: the mechanical fuse

    Shaw, M. | Tema Archiv | 1972
    Schlagwörter: VERFORMUNG

    CFD-CSD analysis of active control of helicopter rotor for performance improvement

    Jain, Rohit / Szema, Kuo-Yen / Munipalli, Ramakanth et al. | Tema Archiv | 2009
    Schlagwörter: Formänderung

    Prüfmethoden für die Crashbelastung von Kunststoffbauteilen

    Kraft, Werner-Wilhelm | Tema Archiv | 2006
    Schlagwörter: Verformung

    Supraduktile und hochfeste Leichtbaustähle für den zu-künftigen Fahrzeugbau

    VDI-Preis für Innovative Werkstoffanwendung 2008
    Frommeyer, Georg | IuD Bahn | 2008
    Schlagwörter: Verformung

    Measurement and minimisation of welding-induced distortions in T-joints between sections

    Staubach, Marten / Müller, Ricus / Jüttner, Sven | Tema Archiv | 2007
    Schlagwörter: Verformung

    Distortion engineering during the manufacturing of aircraft fuselage shells

    Schimanski, Kai / Zoch, Hans-Werner / Keßler, Olaf et al. | Tema Archiv | 2007
    Schlagwörter: Verzug (Verformung)

    Studies on collision-protective structures in nuclear powered ships

    Akita, Y. / Ando, N. / Fujita, Y. et al. | Tema Archiv | 1972
    Schlagwörter: VERFORMUNG

    Effect of a fastener hole design of inlet flanges on the durability of the exhaust manifold for a turbo-diesel engine

    Klm, Beomkeun / Lee, Seong-Beom / Lee, Eunhyun | Tema Archiv | 2007
    Schlagwörter: plastische Verformung , thermische Verformung

    Regenerieren von Federblättern durch elektromechanisches Behandeln

    Rudnik, F.J. / Elkin, S.J. / Chochlov, A.B. et al. | Tema Archiv | 2000
    Schlagwörter: Richten (Formändern)

    Numerical analysis of the straightening process of thin plate structures by elastic FEM based on the inherent strain method

    Vega, Adan / Camano, Alexandra / Blandon, Juan et al. | Tema Archiv | 2012
    Schlagwörter: plastische Verformung

    An numerical analysis of plastic deformation induced rail corrugation

    Wen, Zefeng / Jin, Xuesong / Jiang, Yanyao | Tema Archiv | 2009
    Schlagwörter: plastische Verformung

    Static Aeroelasticity Analysis of High Aspect Ratio Wing and the Jig-Shape Design Based on Multi-Block Structural Grid

    Liu, Yan / Bai, Jun-Qiang / Hua, Jun | Tema Archiv | 2013
    Schlagwörter: elastische Verformung

    Durability Characterization of Coated Materials with Low-Ice Adhesion

    Miranda L Beaudry / Christopher J. Wohl / Joseph G. Smith Jr | NTRS
    Schlagwörter: icing, AERTS Jr, rapid impact deformation, Tabe abrasion

    Methods and Strategies for the Detection and Management of Grid Induced Uncertainties in Numerical Aerodynamics

    Mazlum, E. / Radespiel, R. | Tema Archiv | 2013
    Schlagwörter: lokale Verformung

    Failure analysis of the die in the third hot forging stage of a gear blank

    Santos, C.A. / Aguilar, M.T.P. / Campos, H.B. et al. | Tema Archiv | 2006
    Schlagwörter: plastische Verformung

    Aerolastic tailoring for stability augmentation and performance enhancements of tiltrotor aircraft

    Nixon, M.W. / Piatak, D.J. / Corso, L.M. et al. | Tema Archiv | 2000
    Schlagwörter: Verformungsart

    Cyclic deformability of steel pipes with local metal loss and repaired pipes

    Miwa, Masataka / Oguchi, Noritake / Okajima, Yutaka et al. | Tema Archiv | 2004
    Schlagwörter: plastische Verformung , zyklische Verformung

    On the selection of the mode cut-off number in component mode reduction

    Wamsler, Manfred | Tema Archiv | 2009
    Schlagwörter: Verformung

    Fatigue design of welded components of railway vehicles - influence of manufacturing conditions and weld quality

    Kassner, Manfred / Küppers, Martin / Bieker, Guido et al. | Tema Archiv | 2010
    Schlagwörter: Verformung