1–20 von 58 Ergebnissen
|

    Fundamental studies to improve the performance of aerospace alloys

    Thompson, G.E. / Skeldon, P. / Shimizu, K. et al. | Tema Archiv | 2002
    Consideration is given to the role of alloying elements in aluminium and alloy fabrication on performance during surface treatment and ...

    Methodical approach to the analysis of on-board electrical system architectures fundamental research into the future provision of electrical energy in commercial vehicles

    Oberfell, Ralf / Gast, Stefan / Schwarzhaupt, Andreas et al. | Tema Archiv | 2010
    development of a regenerative braking system in an on-board electrical system as an example, this paper outlines a procedure with which energy paths ...

    Investigation on the design of bonded structures for increased damage tolerance

    Meneghin, Ivan / Pacchione, Marco / Vermeer, Pascal | Tema Archiv | 2009
    A careful choice of the reinforcement materials and their design is fundamental to achieve an effective design solution for fuselage ...

    The effect of rubber contact on the fretting fatigue strength of railway wheel tire

    Kubota, Masanobu / Hirakawa, Kenji | Tema Archiv | 2009
    The cause of the ICE train derailment, which occurred in 1998 at Eschede, was fatigue failure originating on the inside of the wheel tire ...

    In-Flight and Wind Tunnel Investigalions of Instabilities on a Laminar Wing Glove

    Peltzer, I. / Nitsche, W. | Tema Archiv | 2006
    -wire array together with several independent point sources for the controlled experiments were used. Depending on the excitation case, typical ...

    Using chemiluminescence as sensitive detector of early stages weathering effects on car coatings to shorten weathering tests

    Wachtendorf, Volker / Geburtig, Anja | Tema Archiv | 2005
    confronted with a growing, even more fundamental questioning of the law of reciprocity in weathering at all. A successfully practised way out often ...

    Development of High Precision Test Masses for the MICROSCOPE Space Project

    Hagedorn, Daniel / Heyne, Heinz Peter / Metschke, Stephan et al. | Tema Archiv | 2014
    Schlagwörter: fundamental physics

    Impacts and waves in Dyneema HB80 strips and laminates

    Chocron, S. / King, N. / Bigger, R. et al. | Tema Archiv | 2013
    Single-yarn impact results have been reported by multiple authors in the past, providing insight on the fundamental physics involved in ...

    Technical development and commercialization of high quality steels for automotive applications at United States Steel Corporation

    Hyland, R.W. jun. / Becker, J.J. / Hoydick, D.P. et al. | Tema Archiv | 2009
    technology support services. Highlighted examples of our strategic commitment to advanced automotive steel technology will focus on product and ...

    Dynamic PIV measurement of a compressible flow from airbag inflator housing

    Jang, Young Gil / Kim, Seok / Kim, Chang Soo et al. | Tema Archiv | 2006
    air bag system is the most fundamental and effective device. Beside of the front air bag system which installed on most of all automobiles, a ...

    The recent development of advanced automobile steel sheets and long products

    Weng, Yuping / Dong, Han / Gan, Yong | Tema Archiv | 2009
    fundamental research. It is worthy to take more and more efforts on automotive steels to be of high performance in the near future. ...

    Experimental investigations of momentum and heat transfer in pulse detonation engines

    Kasahara, J. / Takazawa, K. / Arai, T. et al. | Tema Archiv | 2002
    has been confirmed, few experimental reports have been based on a fundamental cyclic theory. In the present paper, we apply the Endo-Fujiwara ...

    Venting of deflagrations: hydrocarbon-air and hydrogen-air systems

    Molkov, V. / Dobashi, R. / Suzuki, M. et al. | Tema Archiv | 2000
    hydrogen-air mixtures. New data were obtained on flame stretch for vented deflagrations. The fundamental Le Chatelier-Brown principle analog for ...
    Schlagwörter: Symposium

    Analysis of the fault tolerance of a switched reluctance machine with distributed inverter

    Hennen, Martin / Boesing, Matthias / Doncker, Rik W. De | Tema Archiv | 2012
    damages. It is obvious that this limit strongly influences the maximum available torque after a fault. Due to the lack of an excitation source on ...

    Experimental determination of energy release rate of CRFP structures by means of transverse crack tension tests

    Llopart Prieto, L. / Spenninger, G. / Wagner, H. | Tema Archiv | 2009
    development of damages by means of delamination under static loading, which will help on opening the floodgates to the next generation of sizing ...

    Prediction of LED junction temperatures with CFD for Headlamp Application

    Kikuchi, Kazushige / Hamashima, Yoshihiko / Kobayashi, Yasuke | Tema Archiv | 2005
    junction temperature on a tip under a phosphor is a fundamental challenge for controlling the LED. Although heatsinks serve as basic and reasonable ...

    RCS - Numerical, methodological and conceptional aspects for the analysis of radar distorting objects

    Greving, Gerhard / Biermann, Wolf-Dieter / Mundt, Rolf | Tema Archiv | 2009
    scattering parameter. It is shown in this paper that the RCS does not exist for the WT being installed on the ground due to fundamental reasons ...

    Thermal behavior and mission profile simulations for bending light

    Dari, Alain | Tema Archiv | 2005
    tool based on digital data of cartography. This simulation described in the paper made possible to calculate the duty cycle of the actuator in ...

    Vehicle of the future: the role of the new generation of high strength steel grades

    Fuganti, Antonio | Tema Archiv | 2006
    ) according to two timetables: 140 and 120 g CO2 per km for 2008 and 2012, respectively, measured as an average value on the entire OEM fleet. In ...