1–9 von 9 Ergebnissen
|

    Advanced Research in Aerospace, Robotics, Manufacturing Systems, Mechanical Engineering and Bioengineering : Selected, peer reviewed papers from the OPTIROB 2015 - International Conference on Cyber Systems in the Fields of Aerospace, Robotics, Manufacturing Systems, Mechanical Engineering, June 27-30, 2015, Jupiter, Romania

    Selected, peer reviewed papers from the OPTIROB 2015 - International Conference on Cyber Systems in the Fields of Aerospace, Robotics, Manufacturing Systems, Mechanical Engineering, June 27-30, 2015, Jupiter, Romania | TIBKAT | 2015
    Collection of selected, peer reviewed papers from the OPTIROB 2015 - International Conference on Cyber Systems in the Fields of Aerospace ...

    Development of Spalling Estimation Model for Ball-Type Constant Velocity Joints

    Kim, DongHyuk / Kim, Dongwan / Cho, Jeonghyeon et al. | SAE Technical Papers | 2019
    at the contact points was derived by Hertz contact theory. Third, the maximum sliding speeds at the contact points were also calculated using ...
    Verlag: Society of Automotive Engineers , SAE International

    Disk design methodology for reducing blade vibration in turbine engine rotors

    Baik, Sanghum / Castanier, Matthew P. / Pierre, Christophe | Tema Archiv | 2005
    rotation speed and blade mistuning on the critical stress levels. Second, it was demonstrated that by optimizing only the disk geometry with just a ...

    Dynamic analysis and simulation of vehicles carrying liquids during braking

    Biglarbegian, Mohammad / Zu, Jean W. | Tema Archiv | 2005
    effect of varying amounts of fluid volumes in the tanker were studied using tanker volumes of one-half, one-third, and two-thirds and was shown ...

    Effect of forming and calibration operations on the final shape of large diameter welded tubes

    Palumbo, G. / Tricarico, L. | Tema Archiv | 2005
    calibration phase has also performed under the hypothesis of plane strain condition, but not accurate results have been obtained. On the contrary, the ...

    Improvements to the NVH performance of tripode constant-velocity joints through mathematical modelling

    Lloyd, R.A. / Bartlett, S.C. / Tucker-Peake, A. | Tema Archiv | 1994
    force, tertiary moment, or transmission error have been identified. In tests on a rig and in a vehicle on a rolling road, third-order axial ...

    Method for applying reinforcement learning to motion planning and control of under-actuated underwater vehicle in unknown non-uniform sea flow

    Kawano, H. | Tema Archiv | 2005
    velocity of non-uniform sea flow around obstacles on the seabed before the mission. Third, the effect of the sea flow on the motion of an ...

    Special issue: Powertrain engineering (PMC 2016)

    Powertrain Modelling and Control | TIBKAT | 2017

    The effect of model accuracy and thruster saturation on tracking performance of model based controllers for underwater robotic vehicles: experimental results

    Smallwood, D.A. / Whitcomb, L.L. | Tema Archiv | 2002
    This paper reports an experimental investigation of the effect of two specific errors on a class of model based controllers for the low ...