1–7 von 7 Ergebnissen
|

    A Constitutive Model of Shape Memory Alloys with Consideration of Martensitic Hardening Effect

    Qian, H. / Li, H. N. / Song, G. | ASCE | 2008
    attracted much attention in the past decades. This paper presents experimental characteristics and a constitutive model of superelastic Nitinol SMAs ...
    Schlagwörter: Research

    A Continuous Dynamic Constitutive Model of Shape Memory Alloys

    Yan, S. / Wang, W. / Song, G. | ASCE | 2008
    effect (SME) and the super elasticity effect (SE) of the SMAs was developed in this paper. The work presented was based on the previous work of ...
    Schlagwörter: Research

    DNN and ANFIS Based Modeling and Control of a Thin SMA Wire

    Kilicarslan, A. / Song, G. / Grigoriadis, K. | ASCE | 2008

    In this work, a Dynamic Neural Network (DNN) and an Adaptive Neuro Fuzzy Inference System (ANFIS) based hysteresis modeling and control

     ...
    Schlagwörter: Research

    Observer and Controller Design for Vibration Suppression of a Structure with MR Brakes as Nonlinear Hinges

    Li, L. Y. / Song, G. / Ou, J. P. | ASCE | 2008

    Due to the demands of experiment on cost and repeatability, the model of nonlinear vibration of structures is difficult to establish. In

     ...
    Schlagwörter: Research

    Semi-Active Vibration Control of Stay Cables Incorporated with Magneto-Rheological Fluid Damper

    Liu, M. / Li, H. / Song, G. et al. | ASCE | 2008
    firstly proposed in the present paper. Theoretical analysis, laboratory investigation, and in-situ tests are conducted in this study to verify the ...
    Schlagwörter: Research

    Structural Health Monitoring of a Concrete Column Subjected to Shake Table Excitations Using Smart Aggregates

    Liao, W. I. / Gu, H. / Olmi, C. et al. | ASCE | 2008

    Structural health monitoring of concrete structures under seismic loads has always attracted much attention in earthquake engineering

     ...
    Schlagwörter: Research

    Studies about the Performance of PZT Actuator for Tool Holding System in Micro-EDM

    Flores, A. / Ahuett, H. / García, P. et al. | ASCE | 2008

    The Electro Discharge Machining process (EDM) is capable of producing complex geometrical features with high precision in hardened

     ...
    Schlagwörter: Research