Nondestructive measurement of longitudinal force in rail by device with magnetic anisotrpy sensor
Untersuchungen zur Durchlässigkeit von Phenolharz-Beschichtungsfilmen
Process modelling and design for resin transfer moulding
The role of drapability of fiber preforms in resin transfer molding
Application of a hing-energy-density permanent magnet material in underwater systems
Veritas-X-Liner - ein modernes Bauteil in der automobilen Fluidtechnik
Coalbed methane - some aspects of the australian bowen basin coals
The effects of variable permeability on the wave-induced seabed response
Seasonal variation of relaxation time and attenuation in sediment at sea bottom interface
Speciation of evaporative emissions from plastic fuel tanks
Heterogener Stofftransport von Kohlenwasserstoff-Dampf-Gemischen
Novel cements materials for high-pressure/high-temperature wells
Demonstration of enabling technology for the manufacture of large composite cryogenic tanks
Horizontal well performance evaluation tools and techniques
Combining NMR and density logs for petrophysical analysis in gas-bearing formations
New method for screening surfactants for foam diversion applications
Screening of oil reservoirs for selecting candidates of polymer injection
Kraftstofftanks für Pkw aus Stahlwerkstoffen
Application of soft magnetic powder in electric motors
Entwicklung eines Kohlendioxidsensors für den Unterwassereinsatz
Environmental impact of high-voltage cable lines
The design of composite pressurized tanks with and without liners for use in space applications
Non-destructive residual stress measurement in rail heads and rolling contact fatigue
Chromate-free exterior corrosion protection with the Aviox system
New specialty Viton products for automotive sealing applications
Materialien, Leitungen und Verbindungstechniken für Tanksysteme von Niedrigemissionsfahrzeugen
Composite tank permeation prediction and verification
Application of bi-state magnetic material to an automotive IPM starter/alternator machine
A study on the modeling technique of airbag cushion fabric
Insulated iron powders for automotive applications
Study on the performance of a new type of water-repellent admixture for cement mortar
Care needed to select the right SMC materials and processes
Development of two-layer fuel tube system consisting of adhesive-ETFE and modified-PA 12
Delayed ettringite formation in Swedish concrete railroad ties
Effects of backfill on heat transfer from a buried pipe
Fuel containment - special challenges for the rotomoulding industry
Contribution to a better FBE selection for 3 layer polyolefin coatings