This chapter contains sections titled:
Color and Appearance
Visual Evaluation of Appearance
Specular Gloss Measurement
Visual Evaluation of Distinctness‐of‐Image (DOI)
Measurement of Distinctness‐of‐Image
Visual Evaluation of ‘Orange Peel’
Instrumental Measurement of Waviness (Orange Peel)
The Structure Spectrum and its Visual Impressions
Outlook of Appearance Measurement Techniques
Visual Evaluation of Color
Solid Colors
Metallic and Interference Colors
Color Measurement of Solid Colors
Color Measurement of Metallic and Interference Coatings
Typical Applications of Color Control in the Automotive Industry
Color Measurement Outlook
Weathering Resistance of Automotive Coatings
Introduction
Environmental Impact on Coatings
Natural Weathering
Artificial Weathering
New Developments
Standards for Conducting and Evaluating Weathering Tests
Correlation Between Artificial and Natural Weathering Results
Corrosion Protection
Introduction
General Tests for Surface Protection
Special Tests for Edge Protection, Contact Corrosion, and Inner Part Protection
Total Body Testing in Proving Grounds
Mechanical Properties
General Remarks
Hardness
Pendulum Damping
Indentation Hardness
Scratch Hardness
Adhesion and Flexibility
Pull‐Off Testing
Cross Cut
Steam Jet
Bending
Cupping
Impact Testing by Falling Weight
Stone‐Chip Resistance
Standardized Multi‐Impact Test Methods
Single‐Impact Test Methods
Abrasion
Taber Abraser
Abrasion Test by Falling Abrasive Sand
Scratch Resistance
Crockmeter Test
Wet‐Scrub Abrasion Test
Simulation of Car Wash
Nanoscratch Test
Bibliography, Standards
Specifications and Testing
Automotive Paints and Coatings ; 381-465
2008-02-20
85 pages
Aufsatz/Kapitel (Buch)
Elektronische Ressource
Englisch
Automated testing from specifications
IEEE | 2002
|DAQ Evaluation and Specifications for Pyroshock Testing
TIBKAT | 2021
|DAQ Evaluation and Specifications for Pyroshock Testing
Springer Verlag | 2020
|