This chapter determines the basic hull‐propeller characteristics using propeller design charts and a cavitation criterion. It presents two examples: solution of the optimum rate of revolution problem for a container ship and solution of the optimum diameter problem for a bulk carrier. The examples make use of propeller design charts which have been redrawn on the basis of the Wageningen B‐series polynomials and by Oosterveld and van Oossanen. The chapter summarizes the resistance estimate in the range of the design speed. The design task is defined by analyzing the given data. Based on task brake power and shaft efficiency the available delivered power is computed. The required thrust is calculated based on the resistance, service margin, and thrust deduction fraction. From ship speed and wake fraction the speed of advance of the propeller is determined. The ship speed is taken as a function of required thrust in service.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Hull–Propeller Matching Examples


    Beteiligte:
    Birk, Lothar (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    06.05.2019


    Format / Umfang :

    24 pages




    Medientyp :

    Aufsatz/Kapitel (Buch)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Matching Characteristic of Hull, Enging and Propeller

    Yang, Zongming / Wen, Huabing / Yang, Xinglin et al. | Springer Verlag | 2021


    Hull–Propeller Interaction

    Birk, Lothar | Wiley | 2019


    Propeller : hull vortex cavitation

    Huse, Erling | TIBKAT | 1971


    Propeller-induces hull forces

    Breslin, J.P. | Tema Archiv | 1979


    Propeller – hull vortex cavitation

    Huse, E. | IOS Press | 1972