An instrumented pile load test was performed as part of the foundation design for the Caminada Bay Bridge project in south Louisiana. Both static and dynamic load tests were performed. The load-transfer curve of the test pile was obtained from strain measurements by using sister bar strain gauges at six locations along the pile shaft. The test pile resistance was determined by the Tomlinson method for cohesive soils and by the Nordlund method for cohesionless soils. The dynamic and the static load testing results indicated the test pile did not achieve the desired design resistance. The static analysis model was calibrated on the basis of observations of the pile load testing program. The design pile length was revised to benefit from the shallower scour depths for the revised pile design. The low resistance of the test pile resulted in the engineer's decision to use dynamic testing on the production piles to ensure adequate resistances. Taking advantage of the static load test of the instrumented test pile instead of simply using the smaller resistance factor from dynamic tests, the engineer combined the results of the two test methods and used a combination of resistance factors from both the static and dynamic load tests. This paper presents the evaluation of load test results and the rationale used for the selection of the resistance factor.


    Zugriff

    Download

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Pile Load Test and Implementation of Specifications of Load and Resistance Factor Design


    Untertitel :

    Case Study of Caminada Bay Bridge Project in Louisiana


    Weitere Titelangaben:

    Transportation Research Record: Journal of the Transportation Research Board


    Beteiligte:
    Yoon, Sungmin (Autor:in) / Tsai, Ching (Autor:in) / Melton, James Matt (Autor:in)


    Erscheinungsdatum :

    01.01.2011




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Why the AASHTO Load and Resistance Factor Design Specifications?

    Myint Lwin, M. | Transportation Research Record | 1999



    Load and Resistance Factor Design Calibration for Bridge Pile Foundations

    Roling, Matthew J. / Abdelsalam, Sherif / Sritharan, Sri et al. | Transportation Research Record | 2011


    Design of Hammerhead Bent Cap to AASHTO Load and Resistance Factor Design Specifications

    Brown, Michael D. / Bayrak, Oguzhan | Transportation Research Record | 2006