The Troxler Model 4730 infrared ignition furnace was compared with a standard Thermolyne ignition furnace. Comparisons conducted with a single unit of each furnace type were based on the correction factor for aggregate loss during ignition, accuracy, and the variability of the measured asphalt content and aggregate degradation during ignition. Forty-eight samples representing two nominal maximum aggregate sizes (9.5 and 19.0 mm), four aggregate types (granite, crushed gravel, limestone, and dolomite), and two asphalt contents (optimum and optimum plus 0.5% asphalt content) were tested in each furnace. The results indicated that the correction factors for aggregate loss during ignition were significantly different for each type of furnace, thus requiring a separate calibration for each type of furnace. In practical terms, the differences for all but the 9.5-mm nominal maximum aggregate size (NMAS) limestone and both dolomite mixtures were less than 0.1%. The samples with the optimum plus 0.5% asphalt content were tested by using the calibration factors developed for a particular mix–furnace combination. The results were analyzed in terms of accuracy (bias) and variability (standard deviation). Neither the measured biases nor the standard deviations for the two types of furnaces were significantly different. The results obtained with four sieve sizes (NMAS and 4.75, 2.36, and 0.075 mm) were evaluated for aggregate breakdown. A comparison of the aggregate gradations recovered from both furnaces indicated no significant difference in the degree of aggregate degradation. A round-robin investigation should be conducted to confirm that the precision of the infrared furnace is similar to the precision of the standard furnace.


    Zugriff

    Download

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Evaluation of Infrared Ignition Furnace for Determination of Asphalt Content


    Weitere Titelangaben:

    Transportation Research Record: Journal of the Transportation Research Board


    Beteiligte:


    Erscheinungsdatum :

    01.01.2003




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Ignition method for asphalt content determination

    Zhang, W. | British Library Conference Proceedings | 1997


    Improving accuracy of asphalt content determination by ignition test

    Rodezno, Carolina / Brown, Ray | British Library Online Contents | 2017


    Historical Development of Asphalt Content Determination by the Ignition Method

    Brown, E. R. / Murphy, N. E. / Mager, S. et al. | British Library Online Contents | 1995