To significantly cut the time and cost of tooling development, a reconfigurable discrete die (that is, matrix of individually actuated pins) is being developed for aircraft fuselage parts made by forming sheet metal or molding of composite materials. Each pin in the die is a simple hydraulic actuator outfitted with an in-line NC solenoid valve (NC: numerical control) to control its vertical position. Pin positions can either be set in a closed or open-loop fashion. Once the pins are 'set', then the entire matrix is clamped into a rigid tool. A single pin was constructed to resolve several design issues, including the removal of trapped air in the hydraulic circuit, prevention of hydraulic leakage, motion control, and quantifying the dynamic frictional forces. Because the performance of the single pin was deemed acceptable, a 4 x 4 test die of similar design has been constructed to establish the frictional interactions between adjacent pins, the workability of the pin matrix clamping scheme, and the feasibility of closed and open-loop control of pin positioning.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Development of a reconfigurable tool for forming aircraft body panels


    Weitere Titelangaben:

    Entwicklung eines rekonfigurablen Werkzeugs zum Umformbearbeitung von Flugzeugrumpfbodenelementen


    Beteiligte:
    Walczyk, D.F. (Autor:in) / Lakshmikanthan, J. (Autor:in) / Kirk, D.R. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1998


    Format / Umfang :

    10 Seiten, 9 Bilder, 12 Quellen




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    RECONFIGURABLE FLIGHT GUIDANCE PANELS FOR TRANSPORT CATEGORY AIRCRAFT

    HAUSMANN JEFFREY / BUETHE SCOTT / MARTIN ANDREW | Europäisches Patentamt | 2017

    Freier Zugriff

    Forming magnesium skin panels for aircraft

    Young, H.F. | Engineering Index Backfile | 1957


    Development of press-forming processes for car body panels

    Jacobi,W. / Daimler-Benz,Sindelfingen | Kraftfahrwesen | 1986


    BLENDED WING BODY AIRCRAFT WITH TRANSPARENT PANELS

    PAGE MARK ALLAN | Europäisches Patentamt | 2023

    Freier Zugriff

    Blended wing body aircraft with transparent panels

    PAGE MARK ALLAN | Europäisches Patentamt | 2024

    Freier Zugriff