This paper presents the results of an EMTEC funded project to develop low-cost titanium aluminide automotive valves. The alloy studied was Ti-47Al-2Nb-1.75Cr. In the course of the project over 800 valves were produced using several variations of the permanent mold casting process. Applying pressure during solidification improved the casting fill; however none of the permanent mold casting methods produced pore free as-cast valves. The as-cast microstructures of the valves produced by permanent mold casting were much finer than investment cast microstructures of similar section sizes. Of the permanent mold casting methods, the injection cast method exhibited the finest as-cast structure showing promise as a new method for producing fine grained TiAl components. The room temperature tensile properties of the permanent mold cast material were superior to those of investment cast material with a similar microstructure.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Development of low-cost permanent mold automotive components from titanium aluminide alloy


    Weitere Titelangaben:

    Entwicklung von kostengünstigen Automobilbauelementen durch Dauerformgießen einer Titanaluminiumlegierung


    Beteiligte:
    Keller, M.M. (Autor:in) / Porter, W.J. (Autor:in) / Jones, P.E. (Autor:in) / Eylon, D. (Autor:in)


    Erscheinungsdatum :

    1997


    Format / Umfang :

    8 Seiten, 5 Bilder, 2 Tabellen, 10 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Development of Low-Cost Permanent Mold Automotive Components from Titanium Aluminide Alloy

    Keller, M. M. / Porter, W. J. / Jones, P. E. et al. | British Library Conference Proceedings | 1997


    Development of Low-Cost Permanent Mold Automotive Components from Titanium Aluminide Alloy

    Keller, M. M. / Porter, W. J. / Jones, P. E. et al. | British Library Conference Proceedings | 1997


    Development of low-cost permanent mold automotive components from titanium aluminide alloy

    Keller,M.M. / Porter,W.J. / Jones,P.E. et al. | Kraftfahrwesen | 1997


    Welding of temperature resistant titanium alloy and titanium aluminide

    Broden, G. / Schwantes, S. / Heine, B. et al. | British Library Conference Proceedings | 1993


    Development of titanium aluminide turbocharger rotor

    Nazmy, M. / Staubli, M. / Unverricht, M. et al. | British Library Conference Proceedings | 1994