PLASTIC ATTACHMENT BOSSES have been the focus of many quality concerns. The concerns center around the condition of the plastic attachment boss and its influence on the insertion and retention of fasteners. In tracing the sources of difficulty, two specific problem areas were identified: voids in the area surrounding the core pin hole offer no resistance to fasteners (thereby producing a weak joint); inserting larger screws to compensate for the voids often leads to internal stresses that split the boss. In order to increase our unterstanding of the causes of void formation, we initiated an investigation to determine the effects of processing variables on the finished part. The purpose of this paper is to illustrate the use of computer-aided experimental design and analysis to determine the cause of voids in plastic attachment bosses. Through analysis of experimental results, it was determined that the injection molding process variables impacted the size and distribution of voids in the attachment bosses.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Determination of causes of voids in plastic attachment bosses


    Weitere Titelangaben:

    Ermittlung der Ursache von Hohlraeumen in Stuetzzapfen aus Kunststoff


    Beteiligte:
    Pendergast, P. (Autor:in) / Kottyan, R. (Autor:in)


    Erscheinungsdatum :

    1987


    Format / Umfang :

    5 Seiten, 7 Bilder, 1 Tabelle


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Determination of Causes of Voids in Plastic Attachment Bosses

    Pendergast, P. / Kottyan, R. | SAE Technical Papers | 1987


    Determination of causes of voids in plastic attachment bosses

    Pendergast,P. / Kottyan,R. / GMC,Inland Div.,US | Kraftfahrwesen | 1987


    Statistical analysis applied to structural attachment bosses

    Kottyan,R. / Stefanou,H. / Hmiel,S. et al. | Kraftfahrwesen | 1989


    Statistical Analysis Applied to Structural Attachment Bosses

    Mullins, Everett / Stefanou, Harry / Dipert, Robert et al. | SAE Technical Papers | 1989


    Active bolster with active vent formed in attachment bosses

    ASELAGE BRANDON M / WEST SEAN B / RAINES STACEY H | Europäisches Patentamt | 2015

    Freier Zugriff