For modeling an aircraft tire using the brush model method, the friction coefficient μ between rubber and asphalt should not only be described in terms of the applied pressure and sliding velocity/slip ratio, but also by local temperature inside the contact area. Its influence cannot be neglected, since it leads to significant material property changes. Therefore, investigations on different test rigs are analyzed using thermal recordings of an infrared camera. First measurements are done on a high speed linear tester (HiLiTe), a test rig at the Institute of Dynamics and Vibration Research (IDS) at Leibniz University Hanover, Germany. It allows testing single tread block samples with a constant slip ratio of 100%, that is, pure sliding, on a variety of surfaces such as dry and wet asphalt or concrete, as well as on snow and ice. Results in this paper show that the convection has a smaller impact on tread block cooling than the actual contact between runway surface and sample. Since colder surface temperatures lead to higher friction, this effect antagonizes the excitation frequency, which heats up the rubber sample at high velocities. On long-lasting test sequences a quasi-steady-state friction coefficient might be achieved once these effects start to converge. Still, owing to permanent slip, the abrasion leads to cooling as the hot top layer of the rubber is removed occasionally. In addition to these quasi-steady-state measurements on HiLiTe, the thermal behavior of an aircraft tire is investigated with an autonomously running test rig. It allows realistic testing on an airfield runway by altering load, speed, and slip angle of the tire within and beyond the regions of a passenger aircraft. During the measurements, new and partially unknown effects could be observed. The temperature is mostly influenced by the slip angle followed by speed and load. Furthermore, the contact between tire and runway leads to cooling of the tread but does not affect the temperature inside the grooves. They heat up separately and tend to transfer heat to the tread if the cooling by the runway becomes too low.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Experimental Friction and Temperature Investigation on Aircraft Tires


    Beteiligte:
    Linke, Tim (Autor:in) / Wangenheim, Matthias (Autor:in) / Lind, Hagen (Autor:in) / Ripka, Stefan (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2014


    Format / Umfang :

    29 Seiten, Bilder, Tabellen, 10 Quellen



    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch





    An Investigation of Deflection and Friction Coefficient of Tires

    Lieh, J. / Zhang, H. / Cheng, M. et al. | British Library Conference Proceedings | 1999


    Rolling friction of pneumatic tires

    Kluge, H. / Haas, E. | Engineering Index Backfile | 1939


    Finite Element Framework for the Computation of Runway Friction of Aircraft Tires

    Anupam, Kumar / Santosh Kumar, Srirangam / Kasbergen, Cor et al. | Transportation Research Record | 2017


    Dynamic Properties of Aircraft Tires

    S. K. Clark / R. N. Dodge / G. H. Nybakken | AIAA | 1974