Optimizing the electrical discharge machining (EDM) discharge energy parameters and machine tool control parameters for processing S-03 high-strength steel aerospace components is studied. The aim of this paper was to improve the machining efficient, with regard to the requirements of the recast layer thickness and surface roughness. The design of experiments method was used in the experiments. First of all, peak discharge current (ie) was confirmed to fulfill the requirement of surface roughness and recast thickness, because ie is the uppermost parameter affecting both factors. Secondly, pulse on-time (ton) and open-circuit voltage (U) were in turn to be confirmed. Finally, the machine tool control parameters were adjusted to achieve optimized results regarding the machining efficiency, surface roughness, and recast thickness. This promising technology was advanced for manufacturing the integrated turbine disk in S-03 material. The researched parameters and experiments results concerning machining time, relative electrode wear rate (θ), and the quality of the integrated turbine disk are presented. The results show that: peak current 20 A, pulse on-time 42 µs, open-circuit voltage 100 V, duty factor 70 %, electrode jump motion speed 10 m/min, and electrode jump motion height 6 mm are the best optimized parameters for S-03 high-strength steel.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Influence of Discharge Energy Parameters on S-03 High-Strength Steel for Aerospace Components


    Beteiligte:
    Tang, Lin (Autor:in) / Guo, Yong-Feng (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2013


    Format / Umfang :

    6 Seiten




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    HIGH STRENGTH AEROSPACE COMPONENTS

    RICE EDWARD CLAUDE / LAYMAN MAXWELL / PROCTOR ROBERT F et al. | Europäisches Patentamt | 2017

    Freier Zugriff


    Forging aerospace components

    Furrer, D. | Tema Archiv | 1999


    AI aerospace components

    Heindel, Troy A. / Murphy, Terri B. / Rasmussen, Arthur N. et al. | NTRS | 1991


    Rapid manufacturing of high-integrity aerospace components

    Zhang, Shujun / Raja, Vinesh / Garside, John | Tema Archiv | 2002