Within the framework of the presented project, investigations were conducted into the influence of fast inductive curing on the mechanical-technological properties of adhesive-bonded joints under cyclic loads. With reference to automobile practice, a distinction was made between fast curing in the inside and outside inductive fields. The investigations prove that inside field induction leads to a higher fatigue strength. In contrast with this, a fatigue strength which is significantly lower in part can be established after fast inductive curing in the outside field depending on the process parameters of the induction temperature and the induction variant. With regard to the industrial implementation of fast curing, the objective should, for the portrayed reasons, be fast curing in the inside field. If this is not possible for application-relevant reasons, it is recommended to carry out fast curing in the outside field at a low induction temperature and exclusively in a partial method. On the basis of the investigation results, nearly unaltered properties of the adhesive-bonded joint can thus be obtained even after fast inductive curing.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Properties of inductively cured adhesive-bonded joints under cyclic loads


    Beteiligte:

    Erschienen in:

    Welding and Cutting ; 10 , 3 ; 184-187


    Erscheinungsdatum :

    2011


    Format / Umfang :

    4 Seiten, 5 Bilder, 11 Quellen


    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    Functionally graded adhesive joints under impact loads

    dos Reis, Mateus / Carbas, Ricardo / Marques, Eduardo et al. | SAGE Publications | 2021


    Adhesive-Bonded Single-Lap Joints

    Hart-Smith, L. J. | NTRS | 1973


    Experimental investigation of tubular T-joints under cyclic loads

    Cheng, S.M. / Swamidas, A.S.J. / Wallace, W. et al. | Tema Archiv | 1999



    Fusion or mechanically-assisted adhesive bonded joints

    Pearson,I. / Univ.of Warwick,Advanced Technol.Centre,GB | Kraftfahrwesen | 1995