Crack tip opening angle (CTOA) is becoming one of the more widely accepted properties for characterizing fully plastic fracture. In fact, it has been recognized as a measure of the resistance of a material to fracture, in cases where there is a large degree of stable-tearing crack extension during the fracture process. This type of steady-state fracture resistance takes place when the CTOA in a material reaches a critical value, as typically occurs in low-constraint configurations. Our current research has applied the CTOA concept as an alternative or an addition to the Charpy V-notch and the drop weight tear test (DWTT) fracture energy in pipeline characterization. A test technique for direct measurement of CTOA was developed, using a modified double cantilever beam (MDCB) specimen. A digital camera and image analysis software are used to record the progression of the crack tip and to estimate CTOA using the crack edges adjacent to the crack tip. A steady-state CTOA has been successfully measured on five different strength grades of gas pipeline steel (four low strength grades and one high strength grade: X100). In addition, two-dimensional finite element models (2D FEMs) are used to demonstrate the sequence of the fracture process and the deformation mechanisms involved. The CTOA measurements and models are correlated and agree well.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Crack tip opening angle: Measurement and modeling of fracture resistance in low and high strength pipeline steels


    Weitere Titelangaben:

    Der Rissspitzen-Öffnungswinkel: Messung und Modellierung der Bruchfestigkeit in niedrig- und hochfesten Pipeline-Stählen


    Beteiligte:
    Darcis, P. (Autor:in) / Kohn, G. (Autor:in) / Bussiba, A. (Autor:in) / McColskey, J.D. (Autor:in) / Mccowan, C.N. (Autor:in) / Siewert, T.A. (Autor:in) / Fields, R. (Autor:in) / Smith, R. (Autor:in) / Merritt, J. (Autor:in)


    Erscheinungsdatum :

    2007


    Format / Umfang :

    10 Seiten, 24 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Fracture toughness through a welded pipeline section - Crack tip opening angle criterion -

    Darcis, P.P. / Mccowan, C.N. / Drexler, E.S. et al. | Tema Archiv | 2007


    Measurement and modelling of the crack tip opening angle in a pipeline steel

    Andrews, R. / Chterenlikht, A. / Howard, I. et al. | Tema Archiv | 2002



    A single specimen CTOA test method for evaluating the crack tip opening angle in gas pipeline steels

    Hashemi, Sayyed H. / Howard, Ian C. / Yates, John R. et al. | Tema Archiv | 2004


    Constitutive Behaviour and Crack Tip Opening Angle of Ultra High Strength Steel Sheets

    Petri, N. / Martin, P. / Xu, S. et al. | SAE Technical Papers | 2010