A CO2 laser was used as heating source for hot forging. Powder/metallurgy (P/M) valve seats for car engine was studied by this novel process. The effects of compression ratio and tempering temperature followed by laser irradiation on the microstructures and mechanical properties were investigated. It was indicated that the amount of the recrystallized grains increased with increasing compression ratio, especially when the compression ratio was above a certain value (18.70%), resulting in more refined grains. Good properties including density, radial crushing strength and hardness can be obtained by optimizing processing parameters.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A study on microstructures and properties of P/M valve seats of hot forging by laser irradiation


    Beteiligte:
    Guo, Zuoxing (Autor:in) / Liu, Shuangyu (Autor:in) / Hu, Jiandong (Autor:in) / Wang, Hongying (Autor:in) / Yu, Cai (Autor:in) / Chumakov, A.N. (Autor:in) / Bosak, A. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2007


    Format / Umfang :

    5 Seiten, 11 Quellen




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    Hardened valve seats

    Engineering Index Backfile | 1937


    FLEXIBLE EXHAUST VALVE SEATS

    Beall, A. L. / Heron, S. D. | SAE Technical Papers | 1937


    VALVE MODULES FOR INFLATABLE SEATS

    LEM JEROEN / BOLAND BRIAN | Europäisches Patentamt | 2019

    Freier Zugriff

    Valve forging

    Engineering Index Backfile | 1940


    Sintered Alloy Materials for Valve Seats

    Takahashi,K. / Hiraoka,T. / Urano,S. et al. | Kraftfahrwesen | 1981