In this study the fracture analysis was performed to investigate the damage mechanisms of the turbine disc. To solve this problem, a geometrically complicated FE model with some nonlinearities as contact and elastic-plastic material was created. This study explains the reasons for catastrophic failure of the turbine disc. The analysis performed for several conditions has indicated a few critical regions of the turbine, with operational and excessive rotational speed. The first critical area is located on the corner of the 3rd lower slot of the dovetail-rim region of the disc, where the maximum stress was observed. Fracture of the disc in this zone can occur in the speed range of 14,500-16,000 rpm due to excessive stresses. Damage of the turbine wheel is possible also at lower speed, when the volume of the disc will contain a preliminary fatigue crack. However, accurate estimation of the maximum permissible speed as a function of crack size is possible only with a fracture mechanics analysis. The second dangerous area of the disc is also its middle zone, which can yield at 20,000 rpm. Fracture of the turbine in this zone is very dangerous because the engine casing can be punctured by the larger fragments of the disc. However, the probability of this failure is very small because the speed of 20,000 rpm can only be obtained after disconnection of turbine and compressor. Recommendations: (a) Increase the radius of the lower slot of the serration fitting. (b) Change the dimensional tolerance of the dovetail-rim area of the turbine to unload the critical zone of the 3rd lower slot of the disc.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Failure analysis of turbine disc of an aero engine


    Weitere Titelangaben:

    Schadensanalyse eines Turbinenrades von einem Flugzeugmotor


    Beteiligte:
    Witek, Lucjan (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2006


    Format / Umfang :

    9 Seiten, 10 Bilder, 12 Quellen




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    Design Analysis of a Typical Aero Engine Turbine Disc

    Kumaar, Anuradha | Online Contents | 1996


    Lifting appliance for turbine disc of aero-engine

    CHEN SHOUYU / TU WEIQIANG / LI MING et al. | Europäisches Patentamt | 2020

    Freier Zugriff

    Aero-engine turbine disc lifting appliance and operation method thereof

    LI ZHIPING / HU YITING / SHI XINYU et al. | Europäisches Patentamt | 2020

    Freier Zugriff


    Turbine compounding of piston aero engine

    Ricardo, H.R. | Engineering Index Backfile | 1946