This paper presents preliminary results of a study performed on bent ejectors having applications in the aerospace industry. The ejectors consisted of a simple round primary nozzle and a bent mixing tube. The effects of bend angles on pumping characteristics were studied. A cold flow wind tunnel was used to provide the primary flow of air at ambient temperature at a maximum mass flow rate of 1.6 kg/sec. Velocity and pressure measurements were taken upstream of the nozzle and at the exit of mixing tube. The study was done with and without swirl in the primary flow. It was observed that swirl in primary flow improved the pumping performance of the bent. CFD analysis was performed using a commercial CFD code and the results were compared with the experiments. It was observed that the bend in the ejector had a significant effect on the pumping performance. The entrainment ratio decreased and then increased with the degree of bend. An ejector with a 45 deg bend in the geometry had 28% less entrainment ratio than a same size straight ejector. It was found that swirl in the primary flow improves the performance of the bent ejector. A maximum 17% increase in the entrainment ratio was observed with swirl in the case of a 67.5 deg bent ejector. In both 22.5 deg and 67.5 deg bent ejectors the pressure rise was slightly improved by 20 deg swirl in the primary flow. CFD was generally successful in predicting the trends as observed in the experiment results. CFD predictions of pumping were within 7% of the experiments.
Experimental and CFD study of exhaust ejectors with bent mixing tubes
Experimentelle und CFD-Untersuchung von Abgasejektoren mit Bogenmischrohren
ASME Turbo Expo, 2005 ; 155-165
2005
11 Seiten, 10 Bilder, 5 Tabellen, 13 Quellen
Aufsatz (Konferenz)
Englisch
Engineering Index Backfile | 1950
Experimental Study of Oblong Exhaust Ejectors With Multiring Oblong Entraining Diffusers
Online Contents | 2009
|Experimental investigation of rectangular exhaust-gas ejectors applicable for engine cooling
Engineering Index Backfile | 1945
|Entrainment and mixing in thrust augmenting ejectors
AIAA | 1983
|